Must Have Mods for GT3
The following users liked this post:
EMdoc (04-24-2024)
#48
https://www.designsbyjacob.com/produ...-seat-brackets
https://www.trackspecauto.com/parts/ts001
These brackets tilt the seat back a bit so not so upright - made a big difference. However, I'd really like to come up with an adjustable tilt of some sort . ..
https://www.trackspecauto.com/parts/ts001
These brackets tilt the seat back a bit so not so upright - made a big difference. However, I'd really like to come up with an adjustable tilt of some sort . ..
#49
Installed these rear axle cooling ducts yesterday. Only took about 8-10 minutes and certainly can see the difference. 1st photo is with the old on the left and the upgrade on the right. When I get my 3RS soon I'll put it up on the lift to see how good of a job I did on the install. LOL
The following 3 users liked this post by 07CarreraS:
#50
Race Car
Thanks for the photos!
I will be installing these on my Touring this week.
I will be installing these on my Touring this week.
#51
Addict
Rennlist Member
Rennlist Member
1. Alignment, corner-balance, aero settings
2. Blackmill wind deflectors
3. Giro brake caliper studs
4. Brake pads and fluid upgrades
5. RS Axle cooling ducts
6. Inflatable lumbar cushion for LWB seats
2. Blackmill wind deflectors
3. Giro brake caliper studs
4. Brake pads and fluid upgrades
5. RS Axle cooling ducts
6. Inflatable lumbar cushion for LWB seats
Last edited by GrantG; 05-13-2024 at 11:50 AM.
The following 2 users liked this post by GrantG:
lovetoturn (06-06-2024),
wageslave (05-14-2024)
#52
Not in MA anymore
Rennlist Member
Rennlist Member
#53
Addict
Rennlist Member
Rennlist Member
The following 2 users liked this post by dixonk:
EMdoc (05-15-2024),
Matt(inMA) (05-14-2024)
#55
Rennlist Member
Thread Starter
#58
Burning Brakes
no, you just remove the front two bolts, then insert the bracket. Word of advice, the bolts have loctite or something so you must use the exact wrench specified in the instructions.
#59
Re recline brackets, they are not as necessary in 992 as they were in the 991. Had them in my 991 and they were an absolute must. Given the positioning of the buckets in the 992, however, the tilt effectively increases as you lower the seat. If you are like me and drop your buckets to the floor, very good chance you will not need/want the brackets.
#60
I strontly disagree on this point - I'm 6'3" tall, so drive with mine all the way down, and still WAY too upright for me - even with the brackets, I would like more tilt. Pretty much everyone that's ridden in my GT3T commented on how upright the LWCBs are. While it's greatly improved with the brackets, an adjustable mod with more range would definitely be the ticket!
The following users liked this post:
PTS (06-03-2024)