What did you buy your 991 today thread
#7936
Rennlist Member
To me the wing finishes the car off! I have the NR Racing's version and really like it. I did notice though that the wing blade will bounce slightly when hitting bumps so I made a small piece for the center of the wing which attaches by double sided tape to the ducktail and the blade and took care of that.
The following 7 users liked this post by Andy515:
MingusDew (04-14-2023),
polobai (04-15-2023),
sbrooks64 (04-20-2023),
shyamvenky (04-17-2023),
thesaintusa (04-14-2023),
and 2 others liked this post.
#7938
Drifting
The following users liked this post:
likes2drive911 (04-22-2023)
#7940
Drifting
The following 4 users liked this post by mdcm17:
likes2drive911 (04-22-2023),
Serge911 (04-15-2023),
Tangerine (04-15-2023),
Wing Commander (04-16-2023)
The following users liked this post:
bds (04-17-2023)
#7943
Instructor
Bought SOUL bypass pipes with o2 spacers, a Uniden R8 detector with hardwire kit and a Dragy. The Rennlist thread on the hardwire install was super helpful. Took 15 mins and totally worth it.
Just realized the crest is not pointing where it should. Forgot to say something when I got the tires installed. Whelp
Just realized the crest is not pointing where it should. Forgot to say something when I got the tires installed. Whelp
#7944
Rennlist Member
Today I realized my engine cover latch has come disconneted from the actuator . I have the duct tail so gaining access to the actuator is proving to difficult for me so a trip to the dealer will be required .
This is a friendy reminder to make sure your engine cover latches are securly fastened. This is a terrible design by the engineers at Porsche.
Have a good day all.
This is a friendy reminder to make sure your engine cover latches are securly fastened. This is a terrible design by the engineers at Porsche.
Have a good day all.
#7946
The following users liked this post:
desmotesta (04-17-2023)
#7947
Rennlist Member
I used the Rennline magmount with their magsafe addition mounted next to the PCM. It also blocks the cupholder, but I bought one that mounts to the side of the console that works much better.
#7948
Instructor
Can you swap the pads on those calipers without removing the calipers, or do you have to unbolt the caliper and remove it to swap pads? Also, is the Brembo engraved or just a decal? I’ve been looking at alternatives to the AP Racing 380mm kit, including ways to fit the GT3 steel 380mm rotors and using a spacer for the GT3 or Turbo caliper to fit the Carrera upright if needed. The Brembo calipers looks a lot like the GT3 calipers which makes sense because they’re also made by Brembo.
Pic of the first set he did for me last year
Last edited by Pakman996-991.2; 04-17-2023 at 08:29 PM.
#7950
Rennlist Member
Rennline Magsafe Mount and Cup Holder