991.1 Rotor size increase
The following users liked this post:
polobai (04-15-2021)
#92
Drifting
The following 3 users liked this post by AdamSanta85:
#95
Drifting
Love to see a before photo as well, if you have one. Looks great!
The following users liked this post:
polobai (04-16-2021)
The following users liked this post:
polobai (04-16-2021)
The following users liked this post:
Tier1Terrier (07-19-2024)
#101
Rennlist Member
The following users liked this post:
AdamSanta85 (04-16-2021)
#103
Rennlist Member
Thread Starter
Yea so install was pretty seamless. The biggest PITA as always is the stupid brake wear sensors. Should have just deleted them.
Front was totally plug and play with the GT3/991.2 S+ front pad.
Rear needed the 11mm spacers and longer bolts from Freddy's kit (lewisspeedinnovations@gmail.com), but went on easy and torqued with no issues.
Haven't had a chance to take it for a test drive/bed the pads in yet... maybe in an hour or so once the baby goes to bed. Have a Porsche Road Rally on Sunday, hoping to get to try them out a bit then.
If you are doing rotors anyway, I can't see a reason not to upgrade to the 350/350 setup as it doesn't really cost much more money, looks a lot better, and I expect braking to be improved some too.
Front was totally plug and play with the GT3/991.2 S+ front pad.
Rear needed the 11mm spacers and longer bolts from Freddy's kit (lewisspeedinnovations@gmail.com), but went on easy and torqued with no issues.
Haven't had a chance to take it for a test drive/bed the pads in yet... maybe in an hour or so once the baby goes to bed. Have a Porsche Road Rally on Sunday, hoping to get to try them out a bit then.
If you are doing rotors anyway, I can't see a reason not to upgrade to the 350/350 setup as it doesn't really cost much more money, looks a lot better, and I expect braking to be improved some too.
Last edited by AdamSanta85; 04-16-2021 at 07:33 PM.
The following users liked this post:
polobai (04-17-2021)
#104
Rennlist Member
https://www.acerracing.com/collectio...nium-lug-bolts
I am pretty paranoid though about techs using impact wrenches on them though. Are you applying anti sieze as well?
#105
Rennlist Member
Thread Starter
Interesting. Both those and the acer are 6ALV4 Rated, and look exactly the same lol:
https://www.acerracing.com/collectio...nium-lug-bolts
I am pretty paranoid though about techs using impact wrenches on them though. I Are you applying anti sieze as well?
https://www.acerracing.com/collectio...nium-lug-bolts
I am pretty paranoid though about techs using impact wrenches on them though. I Are you applying anti sieze as well?
Would rather not use anti seize if I can avoid it. Does Titanium have galling issues against aluminum wheels or steel hubs?
Last edited by AdamSanta85; 04-17-2021 at 10:43 AM.