VW/Audi 07K (2.5L 20V I5) Swap Thread
#1036
Rennlist Member
I'm working through a couple of small design changes on the bellhousing, to get the fitment totally dialed in. Also, waiting on the correct hydraulic fitting to arrive... I ordered the wrong one for the Solstice Slave at first (I had assumed that it would be the same fitting that the LS/T56 uses, but it's not).
#1037
Racer
I'm working through a couple of small design changes on the bellhousing, to get the fitment totally dialed in. Also, waiting on the correct hydraulic fitting to arrive... I ordered the wrong one for the Solstice Slave at first (I had assumed that it would be the same fitting that the LS/T56 uses, but it's not).
#1038
Rennlist Member
That figures ,,,, I assumed it would take the same fitting as the V8 version as well . Good thing I didn’t order one yet then . I also emailed Spec about the dual disc clutch . I got an answer back , but I believe it was just a generic answer . All I would really need to see is a pic of the flywheel . I might try getting back in touch again later this week .
Here are some more pics: https://www.ecstuning.com/b-spec-clu...eel/sv81a~spc/
Last edited by vt951; 03-25-2019 at 04:02 PM.
#1039
Racer
Here's a pic of my Spec aluminum flywheel. Note that the part number marked on it is incorrect. SA81A would have an 8-bolt pattern (TT-RS crank). Mine is the SV81A, which has the 6-bolt pattern.
Here are some more pics: https://www.ecstuning.com/b-spec-clu...eel/sv81a~spc/
Here are some more pics: https://www.ecstuning.com/b-spec-clu...eel/sv81a~spc/
#1040
Rennlist Member
#1043
#1045
Mucho envious @hinton , that's my plan next year. I like to run a car relatively stock for a while to get aquainted with it and used to the performance, then change it so I can fully appreciate the extra modifications I make. In this case it looks like I just get 3 iterations 😁
#1046
#1047
I’m going to use standard rotation. Having the header come forward allows endless mounting options, and I’m not against running the exhaust out of the hood haha. Mine is going to be very much a budget build!
#1048
I didn’t map the GTX series, but I did map Alan’s G25-660 and it was perfect. Because I’m sticking to a budget build I will be using a Chinese ball bearing GT35, which are around $450 for a “quality” one.
if anyone needs a compressor mapped let me know, I still have all the info.
#1049
#1050
I tried to find maps on Precision’s website in case people were interested in those but I couldn’t find them? Anyone have access to them? I’d be interested to see what the PT5858 and PT6062 looked like.