Assembling Tial kit
#31
Originally Posted by Sam Lin
The copper gaskets are made by SCE, Specialty Component Engineering, and are part # 4150, "Two Bolt 1.5" Waste Gate Gasket." They sell for around $11 each.
Sam
Edit: Just checked with my distributor, prices have gone up a tad since I bought mine. Edited to reflect the change.
Sam
Edit: Just checked with my distributor, prices have gone up a tad since I bought mine. Edited to reflect the change.
#32
Originally Posted by David Floyd
You know of an online store that would have these ?? everyone I find that carry SCE gaskets, can't get the #4150.
#33
Originally Posted by Ken D
I spoke with SCE, they have "hundreds" in stock, and couldn't figure out why. A brief supplier search on their end found that they were not readily stocked. You can order direct from SCE, the cost is $4.99 each, or custom order from Summit @ $5.99 each. From either place, the shipping/handling charges will be more than the gasket itself.
#34
Question for you guys... I've done about five Tials and on the first three I was able to easily drill out the holes (threads) for the adaptor plates. The last two I've done I've been tearing through bits like you wouldn't believe. Has tial changed something recently? It's like drilling out hardened steel?
#36
Originally Posted by Jeremy Himsel
Question for you guys... I've done about five Tials and on the first three I was able to easily drill out the holes (threads) for the adaptor plates. The last two I've done I've been tearing through bits like you wouldn't believe. Has tial changed something recently? It's like drilling out hardened steel?
Are the bits that you're using possibly the part which has changed in material instead? (Doubtful but ya never know).