RennPartsDirect

Any idea on V2 production retail pricing? I hope it works flawlessly as I am just about to start modifying my center console for a double din. So the faster to market the better!

BigAl1

No idea on pricing yet - mounting fascia and housing will probably be 3D printed parts - not designed yet. Working on the first board assembly so I can test functionality - after that will be the pretty stuff!

MjRocket

I have no problem purchasing a whole new flush mount kit if need be. Your first gen is an awesome piece, I'm sure I could easily sell it.

jeff spahn

i am with MJ I have your flush mount and still haven't installed it yet waiting on this project!

BigAl1

Progress update! Have the first circuit board almost ready for the 3 ***** to be soldered on. Did a first test of the Red/Blue button activation lighting - works as expected, but seems pretty bright without going through the button lens. Still a couple mods to the lighting circuit before I finish the soldering work on this board, then it will be used to finalize the programming and verify the relays work as I want. Also will verify the temp control **** works with the stock setting motor and sensor string. The details learned from this board will be incorporated into the V2 design.
I have found the 2007-2009 Nissan Sentra HVAC ***** are functionally identical to the 2010-2012 *****, and have the same mounting, and light tunnel underneath - in fact, the whole board is almost identical. The 07-09 ***** are slightly smaller OD (middle row in the pics below) and tapered more, so these will probably be the best option for a straight swap of the stock slider unit - will still be a tight fit, but that comes down to the mounting and front trim fascia design.

MjRocket

First dibs!!

Mongo

I am trying to figure out how to keep the wife from seeing this charge hit my credit card when that time comes...

Ninjaxz750

And this is all I have to say about it.....

Tom in Austin

Awesome work, keep it coming!

Madturk

Second dibs. Ready to buy now. Are you taking orders yet??

BigAl1

No orders until this is fully tested. Electronics design is not my forte - so want to be confident it will not cause problems in the field. I will keep moving forward, and update with progress reports.

Koenig-Specials 928

AL being in your neck of the woods and all, just tell me when to drive over and pick mine up

RennPartsDirect

Put me on the list too! Third dibs. This thread is not helping my procrastination on finishing my center console...

yardpro

i am soooo in on this

MjRocket

Bump for any progress updates?