86.5 Intake / Engine Harness / Timing Belt
#301
Rennlist Member
Thread Starter
Just getting started.
First time on scales.
No adjustments have been made since I guessed at ride height correction from what is was before I tore into the front suspension.
But I will certainly have a seat at the wheel with the scale readout in my lap before I'm done.
Cheers,
#302
Rennlist Member
Empty.
Just getting started.
First time on scales.
No adjustments have been made since I guessed at ride height correction from what is was before I tore into the front suspension.
But I will certainly have a seat at the wheel with the scale readout in my lap before I'm done.
Cheers,
Just getting started.
First time on scales.
No adjustments have been made since I guessed at ride height correction from what is was before I tore into the front suspension.
But I will certainly have a seat at the wheel with the scale readout in my lap before I'm done.
Cheers,
This was my 86 5 with 160# in the driver's seat, but before i installed the supercharger. Guess I need to get it back on the scales and see where it is now.
#304
Rennlist Member
Thread Starter
Rim Shots
Not sure how accurate this is, but it looks like only one might be out of spec.
Haven't adjusted anything yet, going to drive it and recheck before adjusting
.
Cheers,
Haven't adjusted anything yet, going to drive it and recheck before adjusting
.
Cheers,
#305
Rennlist Member
Thread Starter
Deja Vu
Oops! How'd that happen? This darn car just keeps taking itself apart.
Found more crusty rubber bits on the floor while checking ride height and alignment so decided to pull these out.
Had I known they were that easy I would have just done them along with the fronts.
At least now I'll know what's in there.
Cheers,
Found more crusty rubber bits on the floor while checking ride height and alignment so decided to pull these out.
Had I known they were that easy I would have just done them along with the fronts.
At least now I'll know what's in there.
Cheers,
The following 2 users liked this post by depami:
Bertrand Daoust (07-07-2024),
booch (07-08-2024)
#307
Rennlist Member
Thread Starter
Bumper Crop
Decent price, fast shipping, excellent packaging. Thanks Roger.
And just to show proper orientation of dust cover spacers:
Cheers,
And just to show proper orientation of dust cover spacers:
Cheers,
Last edited by depami; 07-12-2024 at 09:16 PM.
#309
Rennlist Member
Thread Starter
Perched
They were about 31 and I set them at 35. That should get it pretty close to spec.
Damper adjustment range was about two and a half full turns and I set them 3/4 turn from full stiff.
Cheers,
Damper adjustment range was about two and a half full turns and I set them 3/4 turn from full stiff.
Cheers,
Last edited by depami; 07-13-2024 at 07:44 PM.
#310
Rennlist Member
Thread Starter
Keep Your Bird Feeder Clean!
Bird Feeder Brushes. Who knew? I had no idea there was such a thing. Three bucks for the pair at Menard's.
Cheers,
Cheers,
#312
Rennlist Member
Thread Starter
Pinned
I doped the bushing innards and the pin and held the cone washers in place while lowering the knuckle. A little jiggling and the pin slide right in.
Cheers,
Cheers,