Carl Fausett

Clutch Intermediate Plates! Need used ones for cores so we can rebuild them. Can be worn and grooved, just need the tabs, ring gear, and springs to be OK.

If you have an old one you have replaced, convert it to cash rather than sitting on your garage floor!
$100!

Anybody?

Carl Fausett

Paying $350 per pair of good used front S4/GT brake calipers from 1987-1991.

Anyone?

Carl Fausett

Clutch Intermediate Plates! Need used ones for cores so we can rebuild them. Can be worn and grooved, just need the tabs, ring gear, and springs to be OK.

If you have an old one you have replaced, convert it to cash rather than sitting on your garage floor!
$100!

Anybody?

Carl Fausett

Still need good used oil pans. They can be dirty, just please not all banged up.
Paying $100 cash per good used oil pan, of $120 credit on account.
Paying for shipping too.

Mark Anderson

I can send you 20
tell me how many you want

Carl Fausett

Now I'm looking for 1987-1995 flywheels from AT cars with the ring gears attached. They are worth $50 a piece to us!

Carl Fausett

Looking to purchase any of the following good used parts for cores. Look in that pile in your garage, you may have money laying there!
I pay for shipping the parts to me.

1978-86 Cold Air Funnels with metal bezel from the tops of the radiator fan shroud (see post #65 in this thread) Cash $25 In-store credit $35 per pair.

1978-1980 Non-S Early front spindles Cash $45 In-store credit $60.

1987-1995 Automatic trans flywheels with 60 or 100 tooth timing rings. Cash $35 In-store credit $50.

1978-86 Early throw out bearings cores Cash $65 In-store credit $80.

1978-82 lower bell housing Cash $35 In-store credit $50.

1987-1991 front brake calipers in rebuild-able condition. Cash $85 In-store credit $100. Each.

1983-1995 oil pickup tubes. Cash $25 In-store credit $35

DeWolf

I have an oil pickup with screen from a 91. Shipping might be a bit much though. Although in saying that, the Aussie dollar is down against the US so probably not to bad.

Carl Fausett

Thanks! Yes, the shipping for that part probably makes this a no-go.
The only think I can think of that might be cheap enough is postal. I am in no hurry.

DeWolf

I can find out how much tomorrow if you'd like?

Carl Fausett

Let me save you the trouble. I can get them locally, but thanks for the offer.

DeWolf

You can have if you want it. I was only going to throw it out as scrap. Don't want anything for it. Better if someone can use it.

Carl Fausett

Well, ship it slow-boat cheapest way to:

928 Motorsports
604 E Maple St
Horicon, WI 53032
USA

I'll be sure to get you something for it, at least to pay for your shipping.

Hymodyne

Carl,
I have the bearing from a '79 TOB, not the case its in. I It moves a little but will not turn. Would that be worth sending?

James

Carl Fausett

No thank you, It would not be worth sending.