Anybody have a WUR from their K-Jet car? I am looking to acquire one or two so we can have them rebuilt and offer them as an advance exchange for those that need them.

I'll pay $25 for the WUR, $30 if they are in pretty good appearance. I'll pay the shipping on them too.

 

Looking for flywheels/flex plates from automatic trans equipped 928's. Anybody got any?
They are worth $25 to me if the crank reference timing ring is still on them. And I will pay for the shipping. Let me know.

 

I think I have one but I'm in Canada, you still willing to ship it from here?

 

If we use the Post, yes I think so.

 

Still looking to buy flex plates from automatic trans cars with the timing rings attached.

 

Calipers - especially S4 calipers. Anyone have some they would like to sell? I'd like to rebuild a set or two so I'm ready with an advanced-exchange when the customers call for them...

 

Still looking for 5L blocks?

 

Yes. I had about 12 of them and I am down to 6 and that makes me nervous.

I really have to watch the shipping on these, though. It can raise my cost to where I don't want the block.

Whatcha got (bare block, rotating assembly, etc) , and where is it?

 

Still looking for used throw-out bearings, 1978-86.

I need them for cores - I will pay $75 each for them.

 

Many have replaced their old and broken early radiator fan shrouds. But if
you still have the broken shroud laying in your garage, there might be $40 in it.

I'm buying the cold air plastic "funnel" with the metal bezel for $20 per set, $40 for both of them.

I'll pay for the shipping. You can print a shipping label here:
http://www.928motorsports.com/shipping/

Pics of the parts below. Note only early radiator fan shrouds have removable pieces - the late-model shrouds are molded-in and of no interest to me.

You can drill out the rivets and send the pieces, or if you don't want to, just sawzall that section of the shroud off and send the piece. We will remove the parts from the plastic when it gets here. Don't ship the whole shroud!

 

We need used clutch intermediate plates again. 1980-86 models.

Does not have to be "good" - just complete. We rebuild them, so the center section doesn't have to be good. Does need to have a good ring gear though.

I pay $80 cash or $100 in-store credit for each used intermediate plate core, and I will pay for the ground shipping to get it here.

 

Fire up the 3D printer. Couldn't think of a better application!

 

not QUITE yet - we have explored this possibility but the per-piece costs are still too high. They are coming down... this may be a viable option in another little while.

 

Carl: I have a set of "funnels" without the oval metal inserts - are you interested in them?

Thanks

 

Absolutely!