A/F set up ?
#16
#17
Mark, why don't you post a picture of how it is mounted to clear up any confusion. I don't see how adding the airbox is going to cure a cold start issue but I'll defer to the experts.
#20
John Speaks known good Maf installed, S/C not connected:
Ok; replaced the Temp II sensor, checked for vacuum leaks with my smoker, replaced all the connectors with new ends "Temp II, Coolant and Air Temp, and cleaned grounds on back of motor.
All connections go back with low resistance to the Computers.
Started car will not idle until warm, "same issue":
Upon testing the coolant temp pins to computer pin grounds on the LH and Ezk no resistance is present. The motor grounds are there on the computers pins.
I am at a loss at this point, any other help would be appreciated.
Ok; replaced the Temp II sensor, checked for vacuum leaks with my smoker, replaced all the connectors with new ends "Temp II, Coolant and Air Temp, and cleaned grounds on back of motor.
All connections go back with low resistance to the Computers.
Started car will not idle until warm, "same issue":
Upon testing the coolant temp pins to computer pin grounds on the LH and Ezk no resistance is present. The motor grounds are there on the computers pins.
I am at a loss at this point, any other help would be appreciated.
#25
Found something interesting:
At Lh connector idle switch shows 6.8 Ohms, when on idle 1.270 K ohms
when off idle.
At Wot the switch is not grounding until FULL throttle and is intermittent goes to 9.5 Ohms it shows 1.250 Ohms shows all the time even at idle.
I think my Wot is partially shorted, could be oil; this may explain why I am running rich when warm it stays around 12.1, way to rich!
Any feed back?
At Lh connector idle switch shows 6.8 Ohms, when on idle 1.270 K ohms
when off idle.
At Wot the switch is not grounding until FULL throttle and is intermittent goes to 9.5 Ohms it shows 1.250 Ohms shows all the time even at idle.
I think my Wot is partially shorted, could be oil; this may explain why I am running rich when warm it stays around 12.1, way to rich!
Any feed back?
#26
To get the clearest readings you should disconnect both LH and EZ-F 25way connectors when making these measurements. Then you will get true infinitity and zero ohms readings possible.
Make the measurements again.... then let us know the result.
Make the measurements again.... then let us know the result.
#27
Both connectors where off when I did the readings.
Both Lh and Ezk the readings were identical.
So what would the computers do under this condition?
This is a pain to take out on an 86 but I always like finding something wrong makes the journey relevant.
P.S. My radiator is now leaking things happen in 3's I guess!
Both Lh and Ezk the readings were identical.
So what would the computers do under this condition?
This is a pain to take out on an 86 but I always like finding something wrong makes the journey relevant.
P.S. My radiator is now leaking things happen in 3's I guess!
#30