88porsche928

cam belts still their brand new, just checked, all belts where replaced when engine was swapped

88porsche928

im waiting for a car so i can get a ride to autozone to pick up some materials to make jumper

88porsche928

also i have a question about this jumper, since i swapped out relays and car still didnt start, if it does run with jumper does it mean the lh ecu is bad?

jayc67

Any old short jumper wire will do, doesn't have to be that fancy for a quick troubleshooting job.

Imo000

Use a paperclip. Straighten is out and bend it into a U.

88porsche928

imo000 im not sure if your joking or not. anyways ill look around for a metal wire or paperclip i honestly don't know if i have any paper clips

jayc67

Just shorting across those terminals to make the pump run nonstop for a minute or 2.

88porsche928

just to be safe i will be trying to start the car or just turn the key in the on position and leave it their?

88porsche928

thick metalic wire found possibly from christmas tree inhaging target in 5min

jayc67

Turn the key on first, and see if you hear the fuel pump running. You should be able to hear it.

But yes, go ahead and try to start the car after that.

88porsche928

paper clip turned red hot and started burning some of the plastic so i took it out, i hear a thumping sound when i first put it in

jayc67

Don't think you jumpered the right pins in that case. How thin was the wire you used?

I gotta be honest, this is a pretty entry level troubleshooting thing here. Maybe time to stop and call your mechanic for some help. It only gets more difficult from this point.



Notice the picture on the side of the relay: 30 and 87 are the pins switched by the relay.

88porsche928

tried jumping it again with mutlimeter wires, still heard a thumping noise for a second when connection is made but no constant noise when key is turned

jayc67

Take a look at the JDS page for some more no start troubleshooting.

http://www.jdsporsche.com/fault%20find.html

Stromius

I think you too jumped the wrong ones. 9 o'clock to 3 o'clock (NOT 12!!) like the previous pic suggests.