Guess which job I've just spent 3 hrs doing?
Trending Topics
#8
Thread Starter
Burning Brakes
Joined: Dec 2004
Posts: 819
Likes: 0
From: Staffordshire United Kingdom
#9
#10
Window seals? Are you refering to the scraper seal on the outside of the glass? If so, someone just told me yesterday that you had to dissasemble the door to replace those. If not, I'm sure he will be glad to hear it.
#11
Thread Starter
Burning Brakes
Joined: Dec 2004
Posts: 819
Likes: 0
From: Staffordshire United Kingdom
Yep, scraper seals. If you slacken off the felt pads you can get plenty of clearance between the glass and the door to fit new. Just make sure the top channel is cleared out of any crud and in my case i smeared dow corning release paste (posh silicon) along the channel to make life easier. Like I say, not that bad when you get into it, the second one is easier!
#14
Thread Starter
Burning Brakes
Joined: Dec 2004
Posts: 819
Likes: 0
From: Staffordshire United Kingdom
To be honest Mike it really wasn't that bad. The bottom lip sort of locates itself if you over push it in to the door / glass gap. It springs up and grips. The top lip really is an exercise in brute force, you sort of push it into place and then pull it forward to finish locating it, just use plenty of soap / silicon. I purposely waited for a hot day to do this as the rubber was much more pliable.
I didn't have to trim the seals as the excess just slotted into the frame. When i'd finished i ran a ball end allen key along the gap between the outer seal and the inner section (its a c profile - so allen key into the c to ensure the bottom has located) I used a combination of tips from other posts and it all worked out. I bought my new scrapers 2 years ago and just kept putting it off as i thought it would be an **** of a job. The worst thing is the price!
I didn't have to trim the seals as the excess just slotted into the frame. When i'd finished i ran a ball end allen key along the gap between the outer seal and the inner section (its a c profile - so allen key into the c to ensure the bottom has located) I used a combination of tips from other posts and it all worked out. I bought my new scrapers 2 years ago and just kept putting it off as i thought it would be an **** of a job. The worst thing is the price!