When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
For the rear I’m going to use the lower control arm mounting point, and in the front the Exhaust cross member bolt holes since this is a 78. That should keep the cart tight to the body. Then likely a couple ratchet tie straps for extra measure.
How did you make it fit? I found the connection bars just a bit short so I got 67” tubes cut at my local Metal Supermarket. I also like having solid bars now so I can strap the cart to the car without dealing with the weak point of the bolt on braces it came with.
For the rear I’m going to use the lower control arm mounting point, and in the front the Exhaust cross member bolt holes since this is a 78. That should keep the cart tight to the body. Then likely a couple ratchet tie straps for extra measure.
How did you make it fit? I found the connection bars just a bit short so I got 67” tubes cut at my local Metal Supermarket. I also like having solid bars now so I can strap the cart to the car without dealing with the weak point of the bolt on braces it came with.
Thanks for the input. I hadn’t really addressed how to tie it down yet but that sounds like a good idea.
The bars are at their limit but they did just fit.
On 95 headed north today near hallendale beach blvd. in case the owner is here, I’m the idiot in the polar silver gts that was trying to get your attention...
03-20-2021, 01:20 PM
