There's GOTTA be a cheaper solution.... rattley windows
#31
Under the Lift
Lifetime Rennlist
Member
Lifetime Rennlist
Member
I probably should capture a copy of the archive of Dan's site and possibly host it. Dan lived nearby and had 7 or 8 928s and a huge trove of parts and was always happy to share his knowledge. He was one of the most active participants in our local club. I miss him a lot.
#32
Chronic Tool Dropper
Lifetime Rennlist
Member
Lifetime Rennlist
Member
Not too bad at around $50 each. The car still needs four of them.
You should add 928 International to your browser bookmarks. www.928intl.com gets you there.
You should add 928 International to your browser bookmarks. www.928intl.com gets you there.
#34
Rennlist Member
Doing the nylon guides on the pillar can be a PITA. If yours are badly loose there, try a cable tie around the guide and the pillar to reduce the slack, and see if that helps. Note that I bought years ago a right and left nylon guide, with correct LH and RH part numbers moulded in the nylon, only to find they were BOTH THE SAME HAND! I used a cable tie around the side I didnt have.
jp 83 Euro S AT 56k
jp 83 Euro S AT 56k
Last edited by jpitman2; 03-15-2016 at 01:52 AM.
#36
Rennlist Member
#37
Rennlist Member