What did you buy for your 924/944/968 today?
04-08-2016, 07:10 AM
#61
Advanced
Join Date: Apr 2014
Location: Seacoast NH
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
the holes do a few things, they let air out from under the car, removing the rubber bumper bolt on pieces loses a few pounds, and the holes help lose a small amount of weight as well. If I had my way, they would have been a lot bigger, but I didn't drill them. I could have used a fiberglass rear euro bumper, but during SCCA races I find that you frequently use both your front and back bumper in traffic during starts and generally the first turn, so I wasn't prepared to lose the shock absorption.
04-08-2016, 05:32 PM
#64
Rennlist Member
New ball joints and control arm bushings for my '84. After I put these in and align the front suspension, my car will finally be ready for AutoX!!
awesome lift.
04-14-2016, 04:28 AM
#68
Advanced
Join Date: Mar 2016
Location: Surprise AZ
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Bought a water pump kit (belts and rollers included) from FCPEURO.COM wasn't today but I haven't gotten them yet so does that count? There are so many things I wanted to buy, but my wallet said no. UGHHH !!!!
04-14-2016, 10:21 AM
#70
Rainman
Rennlist Member
Rennlist Member
some relay+socket+fuse block kits, to delete my DME relay.
some little angle shims, to aim down my LED bars in the grille of my 944T bumper.
the LED bars have a 30 degree beam angle and are mounted horizontally, so the light hitting the road isn't as much as it could be, and there is a lot of light going up towards oncoming traffic. the lights have built in adjusters but they are only 10 degrees at a time, which brings the beam too close.
the new shims are about 8* which should be a happy middle point of putting light on the ground, at a good distance.
i use these lights as headlights.
some little angle shims, to aim down my LED bars in the grille of my 944T bumper.
the LED bars have a 30 degree beam angle and are mounted horizontally, so the light hitting the road isn't as much as it could be, and there is a lot of light going up towards oncoming traffic. the lights have built in adjusters but they are only 10 degrees at a time, which brings the beam too close.
the new shims are about 8* which should be a happy middle point of putting light on the ground, at a good distance.
i use these lights as headlights.
04-14-2016, 11:08 PM
#71
Racer
Monday finally got my clutch , timing belt , balance shaft belt and all rollers and tensioners . Lower hose and thermostat today . Clutch release bearing guide tube should be here this coming Monday .
04-15-2016, 04:40 PM
#72
Rennlist Member
New brake pads, and some poly bushings.
For the new engine...
Water pump + hardware + gasket
Belts and rollers kit
Turbo mounting hardware
Some head studs
Stainless / copper exhaust hardware
Motor mounts
Working with Mike Lindsey to get a rebuild kit together... early NA motor, with a 951 piston ring set.
For the new engine...
Water pump + hardware + gasket
Belts and rollers kit
Turbo mounting hardware
Some head studs
Stainless / copper exhaust hardware
Motor mounts
Working with Mike Lindsey to get a rebuild kit together... early NA motor, with a 951 piston ring set.
04-16-2016, 04:17 PM
#73
Freedom Enthusiast
Rennlist Member
Rennlist Member
