What did you buy for your 924/944/968 today?
#61
the holes do a few things, they let air out from under the car, removing the rubber bumper bolt on pieces loses a few pounds, and the holes help lose a small amount of weight as well. If I had my way, they would have been a lot bigger, but I didn't drill them. I could have used a fiberglass rear euro bumper, but during SCCA races I find that you frequently use both your front and back bumper in traffic during starts and generally the first turn, so I wasn't prepared to lose the shock absorption.
#64
Rennlist Member
New ball joints and control arm bushings for my '84. After I put these in and align the front suspension, my car will finally be ready for AutoX!!
#68
Bought a water pump kit (belts and rollers included) from FCPEURO.COM wasn't today but I haven't gotten them yet so does that count? There are so many things I wanted to buy, but my wallet said no. UGHHH !!!!
#70
Rainman
Rennlist Member
Rennlist Member
some relay+socket+fuse block kits, to delete my DME relay.
some little angle shims, to aim down my LED bars in the grille of my 944T bumper.
the LED bars have a 30 degree beam angle and are mounted horizontally, so the light hitting the road isn't as much as it could be, and there is a lot of light going up towards oncoming traffic. the lights have built in adjusters but they are only 10 degrees at a time, which brings the beam too close.
the new shims are about 8* which should be a happy middle point of putting light on the ground, at a good distance.
i use these lights as headlights.
some little angle shims, to aim down my LED bars in the grille of my 944T bumper.
the LED bars have a 30 degree beam angle and are mounted horizontally, so the light hitting the road isn't as much as it could be, and there is a lot of light going up towards oncoming traffic. the lights have built in adjusters but they are only 10 degrees at a time, which brings the beam too close.
the new shims are about 8* which should be a happy middle point of putting light on the ground, at a good distance.
i use these lights as headlights.
#71
Racer
Monday finally got my clutch , timing belt , balance shaft belt and all rollers and tensioners . Lower hose and thermostat today . Clutch release bearing guide tube should be here this coming Monday .
#72
Rennlist Member
New brake pads, and some poly bushings.
For the new engine...
Water pump + hardware + gasket
Belts and rollers kit
Turbo mounting hardware
Some head studs
Stainless / copper exhaust hardware
Motor mounts
Working with Mike Lindsey to get a rebuild kit together... early NA motor, with a 951 piston ring set.
For the new engine...
Water pump + hardware + gasket
Belts and rollers kit
Turbo mounting hardware
Some head studs
Stainless / copper exhaust hardware
Motor mounts
Working with Mike Lindsey to get a rebuild kit together... early NA motor, with a 951 piston ring set.
#73
Freedom Enthusiast
Rennlist Member
Rennlist Member