Custom balance shaft end seal
#77
#80
Hey, I'm interested in getting a set of these for my 87 944 turbo block build that has the 1 piece integrated cover. A couple of questions though.... Are the rear plugs the same just with different sized seals or are the rear plugs different sizes as well? Currently I have rear plugs that came from my 86 block (2 piece design cover) so I'm wondering if ill need to source new rear plugs or if I just need to put the late seals on them.
I measured these:
Late (integrated cover) rear hole with cover mounted to block 1.300 inches
Late seal surface width on the cover 0.230 inches
Early (2 piece cover) rear hole with cover mounted to block 1.340 inches
Early seal surface width on the cover 0.230 inches
Early plug seal surface O.D. 0.940 inches
Early plug seal surface width 0.285 inches
I measured these:
Late (integrated cover) rear hole with cover mounted to block 1.300 inches
Late seal surface width on the cover 0.230 inches
Early (2 piece cover) rear hole with cover mounted to block 1.340 inches
Early seal surface width on the cover 0.230 inches
Early plug seal surface O.D. 0.940 inches
Early plug seal surface width 0.285 inches
Last edited by mahoney944; 08-12-2016 at 01:01 PM.
#86
#89
Didn't you recieve the package yet? Should be delivered few weeks ago. I sent them about 4 weeks ago and it is usually delivered in 6 days.
Came back from vacation and am really busy atm, must bring in 3 weeks
I'll check your tracking info in the morning,
and reply all seal questions here and pms.
Came back from vacation and am really busy atm, must bring in 3 weeks
I'll check your tracking info in the morning,
and reply all seal questions here and pms.
#90
Hey, I'm interested in getting a set of these for my 87 944 turbo block build that has the 1 piece integrated cover. A couple of questions though.... Are the rear plugs the same just with different sized seals or are the rear plugs different sizes as well? Currently I have rear plugs that came from my 86 block (2 piece design cover) so I'm wondering if ill need to source new rear plugs or if I just need to put the late seals on them.
I measured these:
Late (integrated cover) rear hole with cover mounted to block 1.300 inches
Late seal surface width on the cover 0.230 inches
Early (2 piece cover) rear hole with cover mounted to block 1.340 inches
Early seal surface width on the cover 0.230 inches
Early plug seal surface O.D. 0.940 inches
Early plug seal surface width 0.285 inches
I measured these:
Late (integrated cover) rear hole with cover mounted to block 1.300 inches
Late seal surface width on the cover 0.230 inches
Early (2 piece cover) rear hole with cover mounted to block 1.340 inches
Early seal surface width on the cover 0.230 inches
Early plug seal surface O.D. 0.940 inches
Early plug seal surface width 0.285 inches
Left early, right late:
Seals were shipped on jul.18th, and were in your local post office on jul.25 but tracking reports '' notice was left because an authorized recipient was not available.''. If they did in fact sent it back, I'll send them again and shipping is on me.
Make a list and if it comes anywhere near 10 pairs for each type, Ill do it and cover for a few extra pairs to get to at least 40 seals order.
Early:
1- txhokie4life
Late:
1- mahoney944
2- rcarpi2
3- T&T Racing