A simple home-made puller made from two flat washers and three bolts. Not bad for a few dollars.
Bolts: M6 x 75 mm with a thread length of 18 mm, grade 10.9.
Note comments on bolt length and thread length in the following photos.
Washers:
OD = 2.75 inches (~70 mm).
ID = 1.25 inches (~32 mm). Ideally no hole at all, but then it would not be a washer. LOL
Thickness = 0.16 inches (~4 mm).
Bolt circle: 50.8 mm (2.0 inches).
Drill size: 1/4 inch (6.35 mm) to provide a clearance hole for the bolts.