Rennlist - Porsche Discussion Forums
Out of 6 years of darkness:)
Out of 6 years of darkness:)
0 2021/04/15 16:44:17
This was harder to find then a real car!
This was harder to find then a real car!
0 2021/05/03 11:42:12
Dropped off. Next time I see her, she'll be back to life!
Dropped off. Next time I see her, she'll be back to life!
0 2021/05/08 04:53:20
0 2021/06/09 15:08:45
0 2021/06/10 10:18:53
0 2021/06/10 10:19:29
0 2021/06/11 10:39:06
Still no additional vertical movement. Soaked again, will try tomorrow. Turning into an Ironman more than a marathon:)
Still no additional vertical movement. Soaked again, will try tomorrow. Turning into an Ironman more than a marathon:)
0 2021/06/12 14:28:44
0 2021/07/06 10:35:17
Dremeled the whole a little bigger.
Dremeled the whole a little bigger.
0 2021/07/11 15:03:05
Cleaned the post, jb welded it in place. No mod needed, as it fits perfectly!
Cleaned the post, jb welded it in place. No mod needed, as it fits perfectly!
0 2021/07/11 15:03:15
0 2021/07/19 15:14:37
Backside of headliner
Backside of headliner
0 2021/08/07 15:29:54
Missing adjustment screw
Missing adjustment screw
0 2021/08/07 15:30:01
Only screws to remove
Only screws to remove
0 2021/08/07 15:30:07
Warped drip tray
Warped drip tray
0 2021/08/07 15:30:13
Old seal out
Old seal out
0 2021/08/07 15:30:18
New seals
New seals
0 2021/08/07 15:30:23
New seals installed
New seals installed
0 2021/08/07 15:30:29
Before
Before
0 2021/08/15 09:05:47
After
After
0 2021/08/15 09:05:53
Adjustment screw, previously, was set low. Note, the screw is at the bottom of the loop(silver screw).
Adjustment screw, previously, was set low. Note, the screw is at the bottom of the loop(silver screw).
0 2021/08/15 09:06:00
I test ran the roof, all worked well. The back is slightly below the roof line, but better a hair low. Not sure how I’d be able to adjust it up more anyway, screw adjustment is maxed, plus the new rear seal is thicker. It might move up a little more once it softens up in the sun. But, that’s why there’s a drip tray;)
I test ran the roof, all worked well. The back is slightly below the roof line, but better a hair low. Not sure how I’d be able to adjust it up more anyway, screw adjustment is maxed, plus the new rear seal is thicker. It might move up a little more once it softens up in the sun. But, that’s why there’s a drip tray;)
0 2021/08/15 09:06:05
Think it was warped:)
Think it was warped:)
0 2021/09/06 10:08:38
Interesting, previous owner must have cut the upper right corner for some reason. Both were cut like this?
Interesting, previous owner must have cut the upper right corner for some reason. Both were cut like this?
0 2021/09/06 10:09:03
0 2021/09/23 04:56:35
0 2021/09/25 05:01:03
0 2021/09/25 05:01:39
Used a variety of clips to hold it together. Works very well.
Used a variety of clips to hold it together. Works very well.
0 2021/09/27 08:32:36
The glue holds well. Rather than a heat gun, put the box in the sun for an hour. It helped to allow me to stretch it over.
The glue holds well. Rather than a heat gun, put the box in the sun for an hour. It helped to allow me to stretch it over.
0 2021/09/27 08:33:40
0 2021/09/27 08:35:19
Before
Before
0 2021/09/27 08:35:56
0 2021/10/06 08:20:16
Motor removed. Note the arm is missing the wheel(wheel in pieces).
Motor removed. Note the arm is missing the wheel(wheel in pieces).
0 2021/10/06 08:20:48
New wheel installed and back in the track
New wheel installed and back in the track
0 2021/10/09 04:49:27
Black door clips.
Black door clips.
0 2021/10/09 04:54:36
You can see the size difference
You can see the size difference
0 2021/10/09 04:55:26
All done
All done
0 2021/10/09 04:56:09
Before
Before
0 2021/10/18 08:22:09
After
After
0 2021/10/18 08:22:55