18" track wheel for my spyder: which one?
#80
Race Car
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
What tire sizes? I guess the 245/35/18 and 275/35/18 sizes would keep the correct front to rear diameter. Looks like they cost less than the NT01's too. Not sure I'd want to drive to and from the track on those though!
#81
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Thanks for the compliments guys.
As for the tire sizes - I ran the 245/40 and 275/40 in the Nittos and 245/35 and 275/35 in the Hankooks. I dont think I would have got the hankooks if I had to drive to and from the track. I have a basic open trailer I use to get the car there. Although in some ways I would prefer to have the Nittos and be able to just drive to and from.
As for the tire sizes - I ran the 245/40 and 275/40 in the Nittos and 245/35 and 275/35 in the Hankooks. I dont think I would have got the hankooks if I had to drive to and from the track. I have a basic open trailer I use to get the car there. Although in some ways I would prefer to have the Nittos and be able to just drive to and from.
#82
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I have a set of the Victor Innsbruck wheels in 10x18 and 8x18. I first had NT01's on them for track and they were great tires in my opinion. The weight was roughly the same for the entire combo of wheels and tires vs the stock 19" Spyder wheel with the stock rubber. I think it might have saved 2 or 4 pounds overall (for all 4 not each) if I remember right. The wheels are "roll forged" I think is the term used for them. Different than the other Victor wheels. I am pretty happy with them. They seem to be pretty strong considering I hit the front of the inside curb of turn 10 at VIR where there was a little "pot hole" pretty hard. I thought for sure the wheel would be bent but it doesnt seem to be at all.
I wore the outer edges of the front tires because I had very little neg camber. So I had an alignment done and I decided to try the Hankook z214's. They are faster than the nitto's for sure.
At VIR on the full course I was running 2:10's and 2:11's back in May. That was on a very mild alignment with hardly any neg camber. I did do the GT3 front sway bar and Tarret rear bar though.
Last month I had a more aggressive alignment (i think 2.5 degrees neg camber up front) and on the Hankooks I was running consistent 2:08's and 2:09's with a couple 2:07's thrown in.
I was very impressed with this car! It is probably the most fun Porsche street car I have ever owned.
I wore the outer edges of the front tires because I had very little neg camber. So I had an alignment done and I decided to try the Hankook z214's. They are faster than the nitto's for sure.
At VIR on the full course I was running 2:10's and 2:11's back in May. That was on a very mild alignment with hardly any neg camber. I did do the GT3 front sway bar and Tarret rear bar though.
Last month I had a more aggressive alignment (i think 2.5 degrees neg camber up front) and on the Hankooks I was running consistent 2:08's and 2:09's with a couple 2:07's thrown in.
I was very impressed with this car! It is probably the most fun Porsche street car I have ever owned.
#84
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
![bowdown](https://rennlist.com/forums/graemlins/bowdown.gif)
#85
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Look out! The king is moving onto slicks! How the hell am I ever going to catch up to you now? Although the move does makes sense given that you've reached the limits of your current setup.
I guess the z214s are DOT approved, but driving them to the track might be a waste of wear since they're so soft. Are you gonna hook up a mini trailer to the spyder?
![bowdown](https://rennlist.com/forums/graemlins/bowdown.gif)
#86
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I wore the outer edges of the front tires because I had very little neg camber. So I had an alignment done and I decided to try the Hankook z214's. They are faster than the nitto's for sure.
At VIR on the full course I was running 2:10's and 2:11's back in May. That was on a very mild alignment with hardly any neg camber. I did do the GT3 front sway bar and Tarret rear bar though.
Last month I had a more aggressive alignment (i think 2.5 degrees neg camber up front) and on the Hankooks I was running consistent 2:08's and 2:09's with a couple 2:07's thrown in.
I was very impressed with this car! It is probably the most fun Porsche street car I have ever owned.
At VIR on the full course I was running 2:10's and 2:11's back in May. That was on a very mild alignment with hardly any neg camber. I did do the GT3 front sway bar and Tarret rear bar though.
Last month I had a more aggressive alignment (i think 2.5 degrees neg camber up front) and on the Hankooks I was running consistent 2:08's and 2:09's with a couple 2:07's thrown in.
I was very impressed with this car! It is probably the most fun Porsche street car I have ever owned.
![bowdown](https://rennlist.com/forums/graemlins/bowdown.gif)
For those who aren't familiar with VIR, only race cars and V8 Atoms were quicker (around 2:04-6 or so, though some race cars are under 2:00)...
It sounds and looks like Hankook Z214's may be a cheaper alternative to Hoosier R6's? BTW, these are not racing slicks. Anyway, I have a standard to measure against when I go back there in November (first time in a Spyder). I'll be happy if I'm in 2:20's (street tires).
![Big Grin](https://rennlist.com/forums/images/smilies/biggrin.gif)
Last edited by the_vetman; 02-23-2013 at 11:59 AM.
#87
Nordschleife Master
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I just want to experience them once and see how close I can get to 2:00 at Thill and 1:50 at SP. These tires should get me under 1:40 at LS. I'm not planning on getting a trailer so I would drive on them to the track. Probably wait until the Spring of next year as I don't want to get caught in the rain and they probably work better during warmer weather. I may end up only using them at Sears Point since it's so close to home.
![evilgrin](https://rennlist.com/forums/graemlins/evilgrin.gif)
#89
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Matt, that's some great driving. I saw your car at VIR in May and I consistently timed you as you listed above. In fact, you were so fast that I was wondering if your Spyder was turbocharged... I had no idea it was so close to stock!!! ![bowdown](https://rennlist.com/forums/graemlins/bowdown.gif)
For those who aren't familiar with VIR, only well-driven GT3 RS's and full-on race cars were quicker (around 2:04-6 or so)...
It sounds and looks like Hankook Z214's may be a cheaper alternative to Hoosier R6's? BTW, these are not racing slicks. Anyway, I have a standard to measure against when I go back there in November (first time in a Spyder). I'll be happy if I'm in 2:20's (street tires).![Big Grin](https://rennlist.com/forums/images/smilies/biggrin.gif)
![bowdown](https://rennlist.com/forums/graemlins/bowdown.gif)
For those who aren't familiar with VIR, only well-driven GT3 RS's and full-on race cars were quicker (around 2:04-6 or so)...
It sounds and looks like Hankook Z214's may be a cheaper alternative to Hoosier R6's? BTW, these are not racing slicks. Anyway, I have a standard to measure against when I go back there in November (first time in a Spyder). I'll be happy if I'm in 2:20's (street tires).
![Big Grin](https://rennlist.com/forums/images/smilies/biggrin.gif)
I was going to do a 3.8 conversion but the motor deal fell through. I bet with an additional 75-85 HP this car would be faster than a GT3RS or at least very close - with equal drivers in each. But in some ways I am glad the car is pretty much stock. I dont feel like I am "cheating" so to speak. I did do a softronic tune but I dont think it made any real big difference from stock. If anything it may have a bit more top end hp but I would want to dyno to verify that. They claim it adds 10hp though.
It is funny getting surprised looks from Gt3 guys and Vette guys. They dont expect a Boxster to be that fast around the track. Of course on the straights they just eat me up....
From what I am told the Hankooks are not quite as fast as the Hoosiers but they supposedly last longer and are much cheaper. I will probably use them again (if I dont go back to Nittos so I can just drive to the track.)
When are you going in November and with what group? I may try and get in if I have the time to go.
#90