What did you buy your 991 today thread
#1621
Rennlist Member
Very excited! Up next the Mahogany wood interior pieces are being switched out and replaced with carbon Fiber interior including the new carbon fiber and leather steering wheel
#1622
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Yes, but they are a 3-4 week lead time on diffusers. I'm still waiting on that piece. Here's some photos of the chin spoiler and a few more of the baby duck. I think agate is perfect with carbon fiber. It really needs the wheels and diffuser now though.
please excuse my hideous garage walls. Need to get around to that.
please excuse my hideous garage walls. Need to get around to that.
__________________
SOUL PERFORMANCE PRODUCTS
Quality Exhaust Solutions, Fair Pricing, and Outstanding Service
John Gaydos- Owner, Performance Specialist
Cell - (484) 883-6197
johng@soulpp.com
Jon Wheel - Marketing Manager
jwheel@soulpp.com
SOUL PERFORMANCE PRODUCTS
Quality Exhaust Solutions, Fair Pricing, and Outstanding Service
John Gaydos- Owner, Performance Specialist
Cell - (484) 883-6197
johng@soulpp.com
Jon Wheel - Marketing Manager
jwheel@soulpp.com
#1623
Three Wheelin'
#1624
Three Wheelin'
#1627
Rennlist Member
Had my wheels powder coated gloss black. Me like.
#1628
Three Wheelin'
use add a fuse
https://www.amazon.com/DIGITEN-Assor...rds=add+a+fuse
use it with a fuse that goes on when ignition is turned on (i.e. radio)
https://www.amazon.com/DIGITEN-Assor...rds=add+a+fuse
use it with a fuse that goes on when ignition is turned on (i.e. radio)
#1630
Rennlist Member
#1632
Rennlist Member
Its an easy diy job fuse tap from pass side fuse panel. I ran the tap from bottom most fuse 20 amp(which was connected to a charging port under the glove box) then tucked in the wires up along pass side windshield under the headliner right to radar detector holder which is held on by a rear view mirror holder.
The following users liked this post:
RockyTop (02-10-2022)
#1633
Kranzle washer, Mosmatic gun and lance, MTM cannon, nozzle, and quick disconnects, Grid Guards, CarPro mitt, Master Blaster. Car and wheels coated, quick and easy washing.
The following users liked this post:
RockyTop (02-10-2022)
#1634
Are these Carrera Classic 20" you powder coated? Edit: Saw in your following post that 'yes' they are.
I've been contemplating the same. These look really good. Can you take some close up's to see them a bit better?
I have a guards red and I like black rims with GR.
How much did it cost to get that done, if you don't mind sharing?
I've been contemplating the same. These look really good. Can you take some close up's to see them a bit better?
I have a guards red and I like black rims with GR.
How much did it cost to get that done, if you don't mind sharing?
#1635
Three Wheelin'
Its an easy diy job fuse tap from pass side fuse panel. I ran the tap from bottom most fuse 20 amp(which was connected to a charging port under the glove box) then tucked in the wires up along pass side windshield under the headliner right to radar detector holder which is held on by a rear view mirror holder.
Bad ***!!