Jonathan Holm

Turned out well. I was scared as fawk to mess up.
(the car is wet and dirty, but you'll have to live with that.)

gbickham

I'm thinking of doing the same thing. What measurements did you use to center it and between the letters?

Jonathan Holm

It came on a piece of paper like shown on the first picture, I had to center a few letters that were alittle crooked, but I used the same on the paper as they came tho. Then I took the yellow tape and put straight on, made a straight line on the car, meassured how long it was from one side to another, how long the letters was and followed the line on the car with the letters on the new strap. Might mess up your head with my typing, I'm not the best at describing I'm affraid.
Hope it helped.
With regards, HolmaN.

particlewave

Sorry for the low res...I made this a couple of years ago and have since lost the pic, but luckily google had a cached thumb.
If you want the emblem to look correct from all angles, you need a slight upward curve at the end (look at the emblems on new 981's). This will make it look level from the rear.








And here is a new 981.

gbickham

Thanks guys, you were very helpful

Twodan

[QUOTE=Jonathan Holm;11248802]Turned out well. I was scared as fawk to mess up.
(the car is wet and dirty, but you'll have to live with that.)

Funny, I have been thinking of removing mine from my 991. Different strokes I guess.
Dan

Jonathan Holm

[QUOTE=Twodan;11295652]It looks kinda empty without it from my opinion.

esses

the letters aren't big enough... have you seen the size of names on cars these days