-Build Thread- 997.2TT PDK by Esmotor
#16
Rennlist Member
the OP is serious
#21
Progress report number 8, 30 Nov 2016
so today I didn't have much time to work on the car ( as usual :)
I've focused on the fitment and installation location of the methanol pump and tank
I was quite happy with the plan and results.
I'm liking the trunk mat more lool
lool
Little idea to have led strips beneath the tank to easily see the level. I'll wire it to the trunk bulb to activate when the trunk is open
Stripped the paint of the supplied tank braket. Will spray it black
so today I didn't have much time to work on the car ( as usual :)
I've focused on the fitment and installation location of the methanol pump and tank
I was quite happy with the plan and results.
I'm liking the trunk mat more lool
lool
Little idea to have led strips beneath the tank to easily see the level. I'll wire it to the trunk bulb to activate when the trunk is open
Stripped the paint of the supplied tank braket. Will spray it black
#22
Progress report December 7th, 2016
as usual , I've been busy with work and travel.
good news I was able to do some work
1. Finished up the engine bay side install for the methanol injection , I fixed the FAV and hoses
2. On the trunk side I have installed a small fuse box and ran all the wiring for the methanol pump... plus a little tweak that I thought would be useful; which is a three port panel to monitor voltage , 12V port and USB ports... I'll also use it to hook up the battery charger
3. I forgot to paint the tank braket earlier . . so I sprayed it with a truck bed liner that comes in a can . .. nice stuff !
Added an edge rubber thingy... not sure about it though
as usual , I've been busy with work and travel.
good news I was able to do some work
1. Finished up the engine bay side install for the methanol injection , I fixed the FAV and hoses
2. On the trunk side I have installed a small fuse box and ran all the wiring for the methanol pump... plus a little tweak that I thought would be useful; which is a three port panel to monitor voltage , 12V port and USB ports... I'll also use it to hook up the battery charger
3. I forgot to paint the tank braket earlier . . so I sprayed it with a truck bed liner that comes in a can . .. nice stuff !
Added an edge rubber thingy... not sure about it though
#23
Program update , 8th Dec 2016
had fun today to see things coming together
1. I've completed the wiring on the trunk aluminum mat and hooked up the plugs for the methanol pump and hoses of the tank
2. mounted in the car
3. ran the pump on battery power to test with water in the tank for any obvious issues
had fun today to see things coming together
1. I've completed the wiring on the trunk aluminum mat and hooked up the plugs for the methanol pump and hoses of the tank
2. mounted in the car
3. ran the pump on battery power to test with water in the tank for any obvious issues
#24
Progress report December 12th, 2016
today is my birthday
today the focus was on the ECU.
I've remove the steel tray holding the ECU. disconnected the plugs and stripped the wrap on the harness.
identified the wires by color according to the Aquamist supplied diagram.
it went smooth.
I used posi taps and added a little thicker gauge wire to connect the taps to the Aquamist insanely thin wires.
today is my birthday
today the focus was on the ECU.
I've remove the steel tray holding the ECU. disconnected the plugs and stripped the wrap on the harness.
identified the wires by color according to the Aquamist supplied diagram.
it went smooth.
I used posi taps and added a little thicker gauge wire to connect the taps to the Aquamist insanely thin wires.
#26