When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have finally joined the front aero club. A few facts and thoughts.
part number with head light washers. 997-044-802-34
Paid just under $1300 plus tax.
I bought the Rennline mesh just under $300
Paint and install along w/ the mesh $1500
bought new fog light bulbs $40 or so
about $3k
This dude sits low. My 997.1S sits on H&R springs
Took 3.5 days total.
After almost 4 years I finally added badging to the Getty Design ducktail
I was super excited to pick it up and within 4 minutes of leaving the body shop I had already scraped the lip badly. Within 30 minutes it was destroyed. This dude sits low.
I have finally joined the front aero club. A few facts and thoughts.
part number with head light washers. 997-044-802-34
Paid just under $1300 plus tax.
I bought the Rennline mesh just under $300
Paint and install along w/ the mesh $1500
bought new fog light bulbs $40 or so
about $3k
This dude sits low. My 997.1S sits on H&R springs
Took 3.5 days total.
After almost 4 years I finally added badging to the Getty Design ducktail
I was super excited to pick it up and within 4 minutes of leaving the body shop I had already scraped the lip badly. Within 30 minutes it was destroyed. This dude sits low.
You are a Man. You did it, dorked it, and admitted your errors for all of us to learn from. RESPECT.
Even if I was 100% careful had the car flat bedded to our home once I would have tried to pull it back into the garage I would have ripped it off. That little bump going from the driveway into the garage is way to high for it. I will have to literally have to pull my car into the road then put the lip on.
No way to have a car that sits that low without a noselift.
You'll either need a lower lip that doesn't project t down that low or a way to raise the front of the car on demand. Does EMC make a lip for the aero kit front end?
You may want some of that adhesive protection stuff to protect the corners of the bumper even running without the lip until you decide what the permanent solution will be.