Ultimate Motorwerks GT3RS/Turbo 4 Liter Clutch Kit $2,445.00
#48
#49
Rennlist Member
I think those are some wishful numbers at that rpm. Let me find my buddy's Dyno chart he has the same turbos.
#50
Also, the car with be running ProEFI w/ E85. To my knowledge there is no apples to apples comparison, but I'm sure we can get close
#51
Rennlist Member
At 3600 rpm on a billet 20g you're not making over 600 unless dyno operator is generous but good luck hope you get close.
#52
I was trying to say that I'd be hitting full spool at 3,600, not full power
Again, I pulled those power numbers out of thin air lol. I have no idea what I'll be making, but I'd like to think my clutch would be fine for that if I wish to swap turbos in the future.
Again, I pulled those power numbers out of thin air lol. I have no idea what I'll be making, but I'd like to think my clutch would be fine for that if I wish to swap turbos in the future.
#53
Rennlist Member
this is at 1.5Bar on ms109 on dyno dynamics tuned by Todd at protomotive location. The car is an 03 with basic built motor, billet 20g's and supporting mods. He was told by Todd that the clutch you're asking about in these posts will be sufficient for him so you should be good to buy one
I didn't mean to make it like i was stiffing the pot, sorry.
I didn't mean to make it like i was stiffing the pot, sorry.
#54
Rennlist Member
I made 690 to the rear wheels (pulled front driveshaft) 24/20 billets +meth at 1.45 bar.
I have a feeling I'll need a clutch soon, I have an older CM3 now. But it is up there in mileage, probably 30-35k miles on it.
I have a feeling I'll need a clutch soon, I have an older CM3 now. But it is up there in mileage, probably 30-35k miles on it.
#56
Addict
Rennlist Member
Rennlist
Site Sponsor
Rennlist Member
Rennlist
Site Sponsor
Thread Starter
A great clutch kit for those getting ready for this years track season.
I have option for those that want to keep the dual mass flywheel.
I have option for those that want to keep the dual mass flywheel.
#57
#58
Addict
Rennlist Member
Rennlist
Site Sponsor
Rennlist Member
Rennlist
Site Sponsor
Thread Starter
The complete kit is $2,445.00 this includes the 964 LWFS and 764 Sachs Race Engineering pressure plate. Go to the beginning of this thread and look at all the components in the picture.. Cheers!