AndyT

I have a spare 2005 GT3 cup rear wing with supports. No tail base included. Cost on these parts is near 2500. This is a real Cup Wing not an aftermarket part Wing never used, factory white paint perfect.

Asking 1500

zoomzoom

Andy, what is the wing actually made of? CF? Supports in ally or steel?

zicoramone

When you say «tail base» is that the same of Deck lid? Do you know if they sell it separately?

Glen

I have a factory cup tail. Perfect, currently red but obviously can be any color needed. Its the factory bit that goes with the wing above.

zicoramone

Andy and Glen;

Is it like this?

Glen

Yes, I have the decklid and Andy has the other bits, ie wing, supports, end plates. Deck is a cf factory bit. I believe the wing etc is also factory bits.

zicoramone

I'm not sure if it will fit my 99 Mk1. What do you think?
How much for the decklid?

Glen

Yes they will fit Your car fine. 1500$ for the decklid, again it is factory and undamaged, in excellent shape.

zicoramone

Well guys: After several calculations, unfortunately I came to the conclusion that I have to pass this offer.
1.500 $ (rear wing) + 1.500 $ (decklid) + (21% vat Duane rights that I can't escape) = 3.630 $ + Delivery/shipping costs. The final cost it will be (in my case) higher than 4.000 $. The deal is very good and the factory parts are amazing but the fact of being in another continent spoils it for me.
Anyhow, thank you very much and good luck with the sale.

AndyT

wing is carbon fiber and the uprights are flat black aluminum. just like the picture above. I also have new hood pins as well. the tail takes 2

DRG13

Andy/Glen....Are these parts still available? Glen, Can Todd O. put it all together for me, painted yellow and install...I'm guessing yes....My car is stored at MSR now, so I'll be having TOPP do all my maintenance/mods..

-Dan

AndyT

wing is available

LVDell

Dumb question but does the Cup wing and uprigths bolt onto the street GT3 struts or do you have to replace the decklid just like the non GT3 cars?

DRG13

You have to replace the decklid...

LVDell

Thanks!