PN is 996-106-226-52 for anyone who needs this in the future. Took about 20min to change being really careful not to break the new one.

 

Hi, how do i remove the single use clamps?
I have seen people upgrade to metal connectors such as Edelmann 750400 and the one i am going for is Husky Brass connector from Home Depot ... Model # HDA40700AV

 

I would just take some cutters and clip the head off, that should loosen it enough for it to slide out.

 

Or use a screwdriver to pry the ear of the clamp and spread it a bit. Once spread, the clamp will lose its tension and will be easy to remove. The stainless steel clamp can be difficult to cut.

 

Thanks guys. I used some cutters to lop the top off and then peeled off the top layer and slid the bottom layer off. I'm using screw clamps at the moment but I had the original single clamps delivered from Porsche. Now the reverse question, how do I clamp it on? I might stop by dealer and ask them.

 

The proper tool is this one

You can probably get away using something similar.

 

You can usually get oetiker clamps and hose end pliers at plumbing/irrigation supply houses...


You can usually get oeticker