When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
The one removed from my 2003 C4S last week had that number ending in 401, with no "GERMANY" marking.
Did you have to split the block?
From what I can gather the large center nut is supposed to 22mm. Which means its an M97 engine IMS bearing that was improved upon. You have to split the case to change it out, but the good news is that these don't go bad.
Does anyone have any insight into these IMS bearings?
From what I can gather the large center nut is supposed to 22mm. Which means its an M97 engine IMS bearing that was improved upon. You have to split the case to change it out, but the good news is that these don't go bad.
Does anyone have any insight into these IMS bearings?
Negative on splitting the block. Remove the three bolts and out it came. M96 engine.
Last edited by Lady Silver; 01-30-2022 at 07:31 PM.
Negative on splitting the block. Remove the three bolts and out it came. M96 engine.
Negative. The new engines use the unservicable 997 IMS bearing which does not seem to fail and cannot be removed without splitting the case.
Eurocarguy that aluminum tape will be fine. If there is adhesive left on the surfaces when you get around to removing it, just use a little kerosene on a rag to wipe the adhesive off.
Ha! You have a funny way of showing it! In all seriousness....I totally get it.
With that said, and not knowing you...in reviewing this thread (and original) it would seem you're not one to easily give up...like working on cars (beyond basic maintenance) ...and enjoy a challenge? If that's the case, this (unfortunate) situation checks the boxes! So does that mean somewhere deep inside you're actually looking forward to going through this journey over the next 6 months or so?
Like many others, I'm looking forward to learning more about your engine build journey. Because some of us may be closer to a similar decision than we know or want to know!
Ha! You have a funny way of showing it! In all seriousness....I totally get it.
With that said, and not knowing you...in reviewing this thread (and original) it would seem you're not one to easily give up...like working on cars (beyond basic maintenance) ...and enjoy a challenge? If that's the case, this (unfortunate) situation checks the boxes! So does that mean somewhere deep inside you're actually looking forward to going through this journey over the next 6 months or so?
Like many others, I'm looking forward to learning more about your engine build journey. Because some of us may be closer to a similar decision than we know or want to know!
I like cars. I like German cars, specifically Mercedes-Benz. Drove some amazing cars over the years. When I stepped into this Porsche world I thought I could pull it off and was aware of the risks. How bad could it be?
I had no idea I would not be able to drive the car while working on it. It's been stunningly expensive and completely unreliable. It's a classic previous owner knowing what he has and passing it off to next unsuspecting person.
The thought was to get rid of it, but there were no serious offers and the suggestion of it's worth $7 to $10K was really unappealing. I've got $30K + into it. Walking away from that much investment didn't make any sense.
I think I could be working on my home. I think about what the rest of the fleet needs in terms of repair. There is a lot of things I can do with my time. I'm picking up a part time gig this summer to pay for the engine. This is really not fun.
The parts to rebuild the heads alone from FCP is more than $5K. There is a staggering amount of money to spent here and I just picked up the block. For what I have into this I could have several Mercedes SL convertibles. They run and are cheap to maintain. Run away from the 996.