996 RSR (Flying Lizard)
#46
Intermediate
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
#47
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Put a Hartech 3.9 in that bad boy and you’re putting out near 996.2 GT3 power and torque. It would be very trick to build and have a classic Porsche race car that doesn’t require a racing engine and trans rework every ‘x’ hours! US 996 and 997 Cup cars are $60,000-$90,000 for older cars getting long in the tooth, but in decent fettle.
Last edited by hatchetf15; 08-22-2021 at 02:36 PM.
#48
Intermediate
Thread Starter
#49
Former Vendor
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Zimspeed in Germany has all the correct body parts for conversion. In carbon/kevlar. I have their rear bumper and fender extensions. Otherwise I did my build in "budget", bodywise.
#50
Intermediate
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I think it may end up going to Germany where the bodyparts will come from Zimspeed. Not sure yet. Germany is cheaper which is good and will be a fun trip!
#52
#53
Intermediate
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)