Turbo Script door sills
#76
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Thanks for the advice! I've got the drivers side done. Took a while the old fashion way with goo off and sweat. I'm not a fan a of heat gun so close to rubber and plastic! I'll take it slow and safe!
#77
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I just sent a message to him asking for different options. I like the black door sill (I believe is vinyl) with the "laser cut" turbo word he display in his add of ebay. I asked him if he could make that option but anodized in black and leave the word of selection in stainless brush finish...
#78
Drifting
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Very happy with the quality of these sills, highly recommended. Removing 20 year old adhesive was a slow and PIA job. Patience is key for that portion of the job!
The base needed to be corrected for a better fit on mine (both sides), they were too wide due to an indent in that section. Otherwise it would not sit flush and level.
RL Pilotjosh experienced similar issues including length, so something to keep in mind before installing.
https://rennlist.com/forums/993-foru...l#post12283094
Put SunTek protection film on mine too, highly recommended!
The base needed to be corrected for a better fit on mine (both sides), they were too wide due to an indent in that section. Otherwise it would not sit flush and level.
RL Pilotjosh experienced similar issues including length, so something to keep in mind before installing.
https://rennlist.com/forums/993-foru...l#post12283094
Put SunTek protection film on mine too, highly recommended!