993 GT2 EVO build thread "Winter project 2014"
#438
Rennlist Member
Thread Starter
The tranny cooler will be mounted on the side of the tranny. Will share photos once installed.
#439
Rennlist Member
Thread Starter
#441
Rennlist Member
Thread Starter
#443
Rennlist Member
Are you going to duct air to your trans cooler? With the under-tray it's going to get toasty.
I run one also (trans under tray and trans cooler), and needed to increase cooling to trans cooler because temps continued to rise with pump on, on hot days. I have flat panel for rear seat area and cooler is mounted under that with naca duct in rear quarter window ducting air to cooler. I cold post pic if you'd like, however, don't have immediate access to car.
I run one also (trans under tray and trans cooler), and needed to increase cooling to trans cooler because temps continued to rise with pump on, on hot days. I have flat panel for rear seat area and cooler is mounted under that with naca duct in rear quarter window ducting air to cooler. I cold post pic if you'd like, however, don't have immediate access to car.
#445
#446
Rennlist Member
Thread Starter
#448
Rennlist Member
Thread Starter
The sterling-Euro rate is killing me...so I decided to make the Motec stuff my self. I mean, how hard can it be?
The brake and clutch fluid reservoir found it's place. I also have all the hoses and fittings etc. so install those too to make sure I have enough brackets etc.
The brake and clutch fluid reservoir found it's place. I also have all the hoses and fittings etc. so install those too to make sure I have enough brackets etc.
#450
Rennlist Member
Thread Starter
Did some more plumbing today. The airjack system is all hooked up now and so is the fire suppression system.
These plastic zip tie holders are an awesome product! Just drill a 6mm hole and tap the holder into it. Holds like crazy and easy to replace the zip tie or the whole thing.
I also installed the shifter and I gotta say that it is the best feeling shifter in any car I've ever had. Ultra short throws and mad precision!
My friend spent some time fabbing brackets for the Motec display and keypad from aluminium. Will post pictures once they're ready.
All in all the outfitting is going quite well now. Almost there.
From left to right: Air jack valve, power cut-off, fire system release.
These plastic zip tie holders are an awesome product! Just drill a 6mm hole and tap the holder into it. Holds like crazy and easy to replace the zip tie or the whole thing.
I also installed the shifter and I gotta say that it is the best feeling shifter in any car I've ever had. Ultra short throws and mad precision!
My friend spent some time fabbing brackets for the Motec display and keypad from aluminium. Will post pictures once they're ready.
All in all the outfitting is going quite well now. Almost there.
From left to right: Air jack valve, power cut-off, fire system release.