cdr 220 in 993--glove box now won't open
#4
Rennlist Member
yes.... did you just install it? You have to play with it a bit to get it so it doesn't push on/squeeze the little slider/retainer arm for the door.... if it does, the friction will keep the door from opening....just get the radio as far over to the left in the slot as you can.... even 1/8" will make a difference.... you could have also gotten one of the wires behing that hook, preventing it from coming down...
#7
Three Wheelin'
If the glove box is fine with the radio out, the radio cables are fouling the glove box retaining arm.
Pull out and replace radio keeping cables away from right hand side.
There is a narrow opening under the dash where a small hand can help to guide the cable as you push the radio back in.
Test glove box door opening as you push in radio.
Pull out and replace radio keeping cables away from right hand side.
There is a narrow opening under the dash where a small hand can help to guide the cable as you push the radio back in.
Test glove box door opening as you push in radio.
Trending Topics
#10
Three Wheelin'
Unlikely antenna wire - it's on the left of the radio.
However, it's like a rat's nest behind the radio and as far as i can see, just a matter of luck where the cables finally come to rest, once the radio is fully seated.
However, it's like a rat's nest behind the radio and as far as i can see, just a matter of luck where the cables finally come to rest, once the radio is fully seated.