bcoupe968

seatbelt retractors for both sides
seatbelt receivers for both sides
mounting hardware for all pieces
trim covers for mounting hardware (one bolt cover has a mini crack but still installs over the bolt.)


asking $150+shipping for the set

bcoupe968

some people are asking how the retractors are mounted in comparison to older models for a 3 point belt retrofit. I do not know if previous models of the 911 have the mounting hole already installed on the car but I have attached a photo from the 993 to maybe help a little.

1.) just have to remove the 4 screws which hold the rear deck in place

2.) disconnect the speaker wires from each deck speaker

3.) remove the rear deck out of the way

4.) the mounting holes for the seatbelt retractors are the ones pictured slightly above the top brackets for the rear deck screws.

that is the only bolt which holds each retractor into position on the 993 coupe.

hope this may help for comparison purposes with previous versions of the 911.

Brian

JStuart

I don't mean to hijack...but I have a question about removing the rear deck. I need to remove mine and only see 2 screws. Can you tell me where the others are and anything to be careful of?

Thanks!

Jay

bcoupe968

Hi Jay,

Here is a picture of my former 993 with rear seats installed. When you place the seats in the lowered position you should be able to see the rear deck screws holding it in place (circled in red) on the left side there and on the right will be a mirror image.

You can use the seatbelt cutouts (blue) to help you carefully lift the rear deck away from the spot. Pull it away slowly because there are a couple wires back there for the rear defroster and the speaker wires and such.

Brian

JStuart

Brian you made my day...that is exactly what I was looking for!

Thank you!!!

Jay

bcoupe968

bump

bcoupe968

lowered price

bcoupe968

still available

bcameron59

bcoupe, pls email me current asking $ to bc911@telus.net
thx/Brian

bcoupe968

PM sent