WTB: factory RS heater bypass tube
#18
Guru
Lifetime Rennlist
Member
Rennlist Small
Business Sponsor
Lifetime Rennlist
Member
Rennlist Small
Business Sponsor
#21
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Thanks for the link Don.
It was my understanding that the RS shift rod could be reproduced by substituting a stack of washers in place of the rubber bushings in the stock rod. This is what I plan to do.
It was my understanding that the RS shift rod could be reproduced by substituting a stack of washers in place of the rubber bushings in the stock rod. This is what I plan to do.
#24
Noodle Jr.
Rennlist Member
Rennlist Member
#25
Seared
Rennlist Member
Rennlist Member
#26
Technical Guru
Rennlist Member
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
The fabspeed block-off piece will cause hot air to recirculate in the engine compartment, creating basically a convection oven? With the 964RS bypass tube the air is ejected underneath the 993 or with a 964, to the sides.