Ride Height ?-ROW MO30 w/HD's and Sway Bars
#16
Nordschleife Master
Join Date: Jun 2005
Location: Neither Here Nor There
Posts: 5,351
Likes: 0
Received 7 Likes
on
5 Posts
Is corner balancing "required" for street use? No. Getting an even ride height is going to get you most of the way there considering the limited performance envelope experienced during even aggressive street use.
That said, and in line with jimbo's comment, the illogical part is spending the money on the new equipment and installation/alignment and yet not going that little extra way in getting a corner balance done.
I can see both side of this for street use and don't fault anyone either way.
#17
Just to be clear, the italicized post above is not a straight quote from my DIY.
That said, I think Wayne was simply telling 95 C4 993 that he should maximize the camber on the front wheels. I don't think I would agree with this.
Depending on the install, the car, the powertrain, and the driving mission, this could be way overkill and very destructive to tire life.
In my case, my front camber was set at about -1.5 for agreesive street driving. It certainly effected tire wear, even at this setting. The rears were set at about -1.7-1.8. It should be noted that my car was a C4 (read: understeer). These settings are greater than even RS specs.
There are some here who have front cambers over -2.0 (IIRC around -2.2-2.4), but this is more critical for track use.
That said, I think Wayne was simply telling 95 C4 993 that he should maximize the camber on the front wheels. I don't think I would agree with this.
Depending on the install, the car, the powertrain, and the driving mission, this could be way overkill and very destructive to tire life.
In my case, my front camber was set at about -1.5 for agreesive street driving. It certainly effected tire wear, even at this setting. The rears were set at about -1.7-1.8. It should be noted that my car was a C4 (read: understeer). These settings are greater than even RS specs.
There are some here who have front cambers over -2.0 (IIRC around -2.2-2.4), but this is more critical for track use.
#18
Nordschleife Master
Join Date: Jun 2005
Location: Neither Here Nor There
Posts: 5,351
Likes: 0
Received 7 Likes
on
5 Posts
Depends on how you plan to use the car.
With a typical Bilstein/M030 setup lowered to RS or ROW Sport, you can usually get a little over -2 degrees of camber up front. In a C4S, you will probably need more front camber than RWD models, but unless this is for track use, you could most likely go without camber plates.
It really depends on what you plan to buy and how you plan to use it. Once you've narrowed down the choices, I'd post here for advice/confirmation.
With a typical Bilstein/M030 setup lowered to RS or ROW Sport, you can usually get a little over -2 degrees of camber up front. In a C4S, you will probably need more front camber than RWD models, but unless this is for track use, you could most likely go without camber plates.
It really depends on what you plan to buy and how you plan to use it. Once you've narrowed down the choices, I'd post here for advice/confirmation.
#19
Guru
Lifetime Rennlist
Member
Rennlist Small
Business Sponsor
Lifetime Rennlist
Member
Rennlist Small
Business Sponsor
With respect to ride height, if anyone would like a starting point in terms of perch heights -- I can forward (once I return home tonight) intitial settings I generally start with.
Below is one we did Sunday as an example
Below is one we did Sunday as an example