993 3.8 RSR Engine Build
#76
Rennlist Member
Thread Starter
I've attached a copy of the kit. I also got the Motec, wiring harness, injectors and other things needed.
https://www.rothsport.com/Products/E...ore-Rev2-1.jpg
The following users liked this post:
Patrik S (02-21-2020)
#80
I scrolled through the threads pretty quickly. Was a dyno run ever done? If so, was the results posted?
Thanks,
Ken
Thanks,
Ken
#81
Rennlist Member
Thread Starter
Unfortunately I ended up crashing the car during a race and bending the frame. I have since purchased another race car and also another 993 street car as a donor car for all of the race parts that were on my 993. My plan has been to make it a street car that I can drive to the track if I wish. Work has been crazy and after having a child I have been on the fence many times to continue this project and rebuild or just sell all of the parts.
#82
Rennlist Member
Thread Starter
The dyno numbers where 370's I think. 991.1 GT3 RS's could not pull away from me on track and the 997.2 GT3 Cups with pull on me slightly. I have some videos where I was racing two of the GT3 Cups.
The following users liked this post:
993Porsche (08-10-2022)
#83
Rennlist Member
Thread Starter
Thank you. Unfortunately I crashed the car during a race a did a good bit of frame damage. I have purchased another 1996 993 street car in photo below that the plan has been to convert using all of my race parts but building a street car. It was heart breaking, I loved that car. I've been working on my 89 930 build right now and it should be finished soon then I will start on the 993.
#86
Rennlist Member
I am sure we don't see the entire issue but I know I have seen what appears to be worse tubs straightened. It should cost you less than cutting up another car.