Harness bar minimal roll bar
#1
Harness bar minimal roll bar
Id like something that I can wrap a harness around for Hans and keep my *** in the seat.
Its not for flipping over, don't care.
They exist for 992?
Its not for flipping over, don't care.
They exist for 992?
The following users liked this post:
gman3280 (08-15-2024)
#3
#4
#5
Racer
Joined: Dec 2019
Posts: 345
Likes: 319
From: VA, NC and SC . Up and down the damn road too much
The following users liked this post:
jetprop (09-11-2024)
#7
I would have preferred a simple harness-only bar like this if it existed at the time. I almost just had one made myself but in the end went with a BBi bar.
Trending Topics
#8
LOL
I would..
I figure it needs rear seat belt anchor points, I guess there is no other way then to weld in plates, even with a half assed harness bar.
I would..
Not sure the GT3 rear deck has the threaded inserts in the body from the seat belt attachments of the regular 992 cars that that bar uses.
I would have preferred a simple harness-only bar like this if it existed at the time. I almost just had one made myself but in the end went with a BBi bar.
I would have preferred a simple harness-only bar like this if it existed at the time. I almost just had one made myself but in the end went with a BBi bar.
#9
#10
#11
The following users liked this post:
Apex Ace (08-16-2024)
#13
#14
When you installed it on the 992, were you able to attach it to the intermediate shelf? Looks like they now list the 992 GT3 on the application list so they must have addressed it in some way after all even though the kit looks identical. If it all bolts up as designed, then I would agree it likely fits the bill for a simple harness bar for those that want one.
#15
Hmm, the 991.2 GT3 has the threaded bosses on the intermediate shelf, but the 992 GT3 (at least mine) did not and the holes were no longer threaded. That FVD harness bar bolts to the shock tower and then has an additional diagonal kicker (with the circular holes) that goes from the bar down to the intermediate shelf with holes presumably for screwing it in, but there are no longer threaded holes there on the 992. My friend that bought the 991.2 GT3 FVD bar (looks identical to that one) had to omit this diagonal structure on his 992 because it couldn't be fully attached.
When you installed it on the 992, were you able to attach it to the intermediate shelf? Looks like they now list the 992 GT3 on the application list so they must have addressed it in some way after all even though the kit looks identical. If it all bolts up as designed, then I would agree it likely fits the bill for a simple harness bar for those that want one.
When you installed it on the 992, were you able to attach it to the intermediate shelf? Looks like they now list the 992 GT3 on the application list so they must have addressed it in some way after all even though the kit looks identical. If it all bolts up as designed, then I would agree it likely fits the bill for a simple harness bar for those that want one.