What did you buy your 991 today thread
#4561
Rennlist Member
Join Date: Jul 2001
Location: Marineland FL
Posts: 12,533
Likes: 0
Received 3,458 Likes
on
2,361 Posts
Very easy to remove and mine look fine as I have the pleather visors, and if one has alcantara there may be another way.
#4563
Drifting
https://rennlist.com/forums/991/1137...un-visors.html
This is how I did it on my Alcantara visors. Simple and came out great! You can still see a faint impression so I would say the end results are similar to how yours came out.
This is how I did it on my Alcantara visors. Simple and came out great! You can still see a faint impression so I would say the end results are similar to how yours came out.
#4564
Rennlist Member
Join Date: Jul 2001
Location: Marineland FL
Posts: 12,533
Likes: 0
Received 3,458 Likes
on
2,361 Posts
I opened the doors and flipped the visors over and out so that they were flat/horizontal. I soaked a paper towel with 91 rubbing alcohol and let it sit on the label for about 10 minutes from what I recall. Then I removed the paper towel and started slowly removing the label, which surprisingly came right off. I had to use a little alcohol on a cottonball for a couple stubborn spots but it cleaned up nicely afterwards. There is a very slight shadow of where it was but you have to look very closely and only see it in certain light. It is usually the 1st mod I do to every vehicle.
The following users liked this post:
Need4S (05-28-2020)
#4565
#4567
Drifting
Coming along!
The following users liked this post:
shammerman (05-28-2020)
The following 6 users liked this post by mfonseca:
jesm (05-23-2021),
Monetthecat (05-29-2020),
myrr (05-28-2020),
Nyati (05-28-2020),
t-design (06-01-2020),
and 1 others liked this post.
The following 5 users liked this post by Nyati:
CarreraJimmy (05-30-2020),
phefner (05-28-2020),
rockrdude (06-02-2020),
Scott in NC (06-06-2020),
Wing Commander (05-29-2020)
#4572
Rennlist Member
Mfonseca - car looks great - I'm thinking about doing the same. How hard was the install of the DB Carbon trim kit? Did you remove the doors to do the door trim or did you use DB's tape-on pieces. Thanks
The following users liked this post:
Steven31371 (05-29-2020)
#4574
Rennlist Member
My new 991.1 mods
OEM front sport lip professionally painted to match.
Black vinyl headlight surrounds.
I like both results. I am planning on adding the rear OEM GT3 Touring lip and professionally getting it painted and installed as well to balance aero.
ero.
Black vinyl headlight surrounds.
I like both results. I am planning on adding the rear OEM GT3 Touring lip and professionally getting it painted and installed as well to balance aero.
ero.
#4575
Rennlist Member
Join Date: Jul 2001
Location: Marineland FL
Posts: 12,533
Likes: 0
Received 3,458 Likes
on
2,361 Posts
Nice, even the bugs go well with it all.