Notices
991 2012-2019
Sponsored by:
Sponsored by:

Oil temp

Thread Tools
 
Search this Thread
 
Old Sep 14, 2013 | 01:26 PM
  #1  
mdkrp's Avatar
mdkrp
Thread Starter
Burning Brakes
 
Joined: Apr 2013
Posts: 773
Likes: 102
From: AZ
Default Oil temp

Anyone know how long (time or distance) it tyically takes for the car to get to proper temp?
It seems to me that mine takes an inordinate period of time. Half the time I drive it in regular mode and sport mode.
Thanks
Reply
Old Sep 14, 2013 | 03:05 PM
  #2  
fester's Avatar
fester
Burning Brakes
10 Year Member
 
Joined: Mar 2012
Posts: 1,132
Likes: 303
From: CA, SF Bay Area
Default

Do you have power kit? It comes with 3 radiators which keep the car cold most of the time and even longer time to heat up.
Reply
Old Sep 14, 2013 | 03:27 PM
  #3  
LexVan's Avatar
LexVan
Banned
 
Joined: Jan 2013
Posts: 26,140
Likes: 5,464
From: Chicagoland Area
Default

One of the whole ideas behind the new 991 is it's thermal management system. Car gets up to temp fast. Both the engine and gearbox. This helps with fuel economy.
Reply
Old Sep 14, 2013 | 05:33 PM
  #4  
rnl's Avatar
rnl
Three Wheelin'
10 Year Member
 
Joined: May 2012
Posts: 1,341
Likes: 545
From: Pennsylvania
Default

at a 60f ambient temperature i can take around 6 miles to reach 194F but the coolant is at 194f in 2 miles. It is my understanding that the oil temp sensor is a leftover from the days when the cars were air cooled. that said, i do not use wot until the oil is full warmed up, however, it probably ok when coolant is hot.

i never use sport until the car is warmed up as it seems to have a special circuit to cool the oil
Reply
Old Sep 14, 2013 | 11:35 PM
  #5  
kosmo's Avatar
kosmo
Race Director
 
Joined: Nov 2009
Posts: 10,594
Likes: 8
From: THE Republic
Default

drive it in Normal mode until operating temps are reach. Then Sport is fine.
You'll notice the engine runs about 20-25F cooler in Sport.
Reply
Old Sep 15, 2013 | 01:01 PM
  #6  
mdkrp's Avatar
mdkrp
Thread Starter
Burning Brakes
 
Joined: Apr 2013
Posts: 773
Likes: 102
From: AZ
Default

Thanks for the info guys. I will continue to monitor it
Reply
Old Sep 15, 2013 | 02:27 PM
  #7  
John 996 TT Cab's Avatar
John 996 TT Cab
Burning Brakes
 
Joined: Oct 2010
Posts: 1,028
Likes: 4
From: North Vancouver, BC
Default

I have Powerkit and it takes about 6 miles to get oil temp over 165'F. My dealer service people advise never use WOT below that level. Water temp gets to 180'F in about 2 miles. The manual indicates (I think) never go over 6200 until fully warmed up and oil being up to temperature is an important part of that equation.
Reply
Old May 10, 2014 | 07:43 AM
  #8  
LexVan's Avatar
LexVan
Banned
 
Joined: Jan 2013
Posts: 26,140
Likes: 5,464
From: Chicagoland Area
Default

Wanted to bring up this older thread again, and get more discussion going, and feedback from other owners.

IT TAKES FOR-EVER for the oil to heat up in this car. Note, I have the powerkit, too. Now that I am done with the break-in period, I'm watching the oil temp like a hawk, so I can start partytime ASAP. Coolant heats up fast.

I can see the effect of "normal" mode vs "sport plus" mode on the highway cruising. I was surprised to see how much cooler the oil runs in sport plus mode.

So, in the early, cool, mornings, on first drive out, should I run the car in normal mode to heat the oil up the fastest? Thanks.
Reply
Old May 10, 2014 | 10:26 AM
  #9  
gota911's Avatar
gota911
Newbies Hospitality Director
Lifetime Rennlist
Member
 
Joined: Apr 2005
Posts: 18,084
Likes: 43
From: Winston-Salem, NC
Default

I think your statement immediately preceeding your question answewed your question.

In other words... Yes.
Reply
Old May 10, 2014 | 12:03 PM
  #10  
chuckbdc's Avatar
chuckbdc
Race Car
10 Year Member
 
Joined: Jun 2012
Posts: 3,628
Likes: 346
From: Maryland USA
Default

As I understand it, initial warm up time is the same no what mode you are in: the thermal management system routes water and oil through their radiators/coolers to optimize warm up time to normal operating temperatures. It takes a couple of miles (more if its colder) to get to operating temps. After that pushing buttons affects the fluid routing, so you see the effects, and when temps get high enough the thermal management system (sensors and change over valves) does as it is mapped to do again.
Reply
Old May 10, 2014 | 06:28 PM
  #11  
John 996 TT Cab's Avatar
John 996 TT Cab
Burning Brakes
 
Joined: Oct 2010
Posts: 1,028
Likes: 4
From: North Vancouver, BC
Default

Under no circumstances should you to into Sport or Sport + until oil temperature at 165' F. This is according to the techies at my dealership. This can take 6-7 miles. Water temp ok at about 2 miles but oil is more important.
Reply
Old May 10, 2014 | 08:22 PM
  #12  
gt3fantasy's Avatar
gt3fantasy
Instructor
 
Joined: Sep 2013
Posts: 184
Likes: 3
Default

Originally Posted by John 996 TT Cab
Under no circumstances should you to into Sport or Sport + until oil temperature at 165' F. This is according to the techies at my dealership. This can take 6-7 miles. Water temp ok at about 2 miles but oil is more important.
ooops!!!!!! I must've missed that in the manual.
Reply
Old May 10, 2014 | 08:24 PM
  #13  
LexVan's Avatar
LexVan
Banned
 
Joined: Jan 2013
Posts: 26,140
Likes: 5,464
From: Chicagoland Area
Default

Originally Posted by John 996 TT Cab
Under no circumstances should you to into Sport or Sport + until oil temperature at 165' F. This is according to the techies at my dealership. This can take 6-7 miles. Water temp ok at about 2 miles but oil is more important.
Why? As long as you/I keep the revs below 4,000.
Reply
Old May 11, 2014 | 02:06 AM
  #14  
wanderfalke's Avatar
wanderfalke
Racer
 
Joined: Mar 2014
Posts: 449
Likes: 1
Default

My oil takes forever to warm up to 165. The only time it warms up faster is when the pdk lugs the motor on long uphill grades and who wants that.
Reply
Old May 11, 2014 | 02:41 AM
  #15  
Larson E. Rapp's Avatar
Larson E. Rapp
Rennlist Member
10 Year Member
 
Joined: Aug 2012
Posts: 8,094
Likes: 2,626
From: Pac NW
Default

Originally Posted by gt3fantasy
ooops!!!!!! I must've missed that in the manual.
It's right next to the part about changing the Bose-Einstein dielectric in the flux capacitor every 6 months or 20 parsecs, whichever comes first.
Reply



All times are GMT -3. The time now is 03:06 PM.