Changing the hood crest
#47
So I ordered one off eBay...I think it's CarerraEast judging by the quality - it's top notch.
However it's a badge from a 996 and the posts are about 1mm-1.5mm different than the 991. It's hard to see side-by-side. But when you compare with the 991 rubber gasket the difference is quite obvious.
Not sure what I'm going to do since it looks wrong when I installed it. So I took it off. Perhaps Dremmel off the posts and just 3M tape it.
However it's a badge from a 996 and the posts are about 1mm-1.5mm different than the 991. It's hard to see side-by-side. But when you compare with the 991 rubber gasket the difference is quite obvious.
Not sure what I'm going to do since it looks wrong when I installed it. So I took it off. Perhaps Dremmel off the posts and just 3M tape it.
#48
Jim will be happy to exchange it if you ask him; however, if it fits the recessed area on your frunk lid well you could do that. Either way, use some 3M tape, which Jim suggests and what I did albeit mine lined up:
The following users liked this post:
pissedpuppy (12-06-2021)
#49
Reviving an old thread. Anyone buy a crest replacement from Elite Auto? Wondering about the quality and fit.
https://eliteauto3k.com/products/por...BoC23YQAvD_BwE
https://eliteauto3k.com/products/por...BoC23YQAvD_BwE
#50
Reviving an old thread. Anyone buy a crest replacement from Elite Auto? Wondering about the quality and fit.
https://eliteauto3k.com/products/por...BoC23YQAvD_BwE
https://eliteauto3k.com/products/por...BoC23YQAvD_BwE
I'm wondering about this myself? I went to the "contact" page and didn't find an email or phone number. Seems odd?
#51
Reviving an old thread. Anyone buy a crest replacement from Elite Auto? Wondering about the quality and fit.
https://eliteauto3k.com/products/por...BoC23YQAvD_BwE
https://eliteauto3k.com/products/por...BoC23YQAvD_BwE
The following users liked this post:
ChuckTaylor (01-02-2022)