RS style Carbon side vent inlet scoop group buy
#363
The following users liked this post:
Carbonlution (12-09-2020)
The following users liked this post:
GT3ZZZ (12-08-2020)
The following users liked this post:
Carbonlution (12-14-2020)
#369
Received mine last week and have now fitted them. As per @rodsky, the RHS was slightly off, putting the parts on a flat surface showed it rocked a bit when the LHS sat flat. Would have thought a straight invert of the LHS piece on CAD would have yielded a perfect RHS. Anyway, Carbonlution supplied extra strips of double sided tape so applying these on top of the pieces attached to the parts did the job and I now have a solid and snug fit on both sides. The clips at the rear of the parts engage perfectly but the leading edge has no tabs like the OEM piece, hence the tape. A tube of glue was also supplied but not needed. No problems with the finish or weave. Overall I'm happy.
Last edited by GT3ZZZ; 12-20-2020 at 03:59 PM.
The following users liked this post:
Carbonlution (12-25-2020)
#370
Received mine last week and have now fitted them. As per @rodsky, the RHS was slightly off, putting the parts on a flat surface showed it rocked a bit when the LHS sat flat. Would have thought a straight invert of the LHS piece on CAD would have yielded a perfect RHS. Anyway, Carbonlution supplied extra strips of double sided tape so applying these on top of the pieces attached to the parts did the job and I now have a solid and snug fit on both sides. The clips at the rear of the parts engage perfectly but the leading edge has no tabs like the OEM piece, hence the tape. A tube of glue was also supplied but not needed. No problems with the finish or weave. Overall I'm happy.
#371
Received mine last week and have now fitted them. As per @rodsky, the RHS was slightly off, putting the parts on a flat surface showed it rocked a bit when the LHS sat flat. Would have thought a straight invert of the LHS piece on CAD would have yielded a perfect RHS. Anyway, Carbonlution supplied extra strips of double sided tape so applying these on top of the pieces attached to the parts did the job and I now have a solid and snug fit on both sides. The clips at the rear of the parts engage perfectly but the leading edge has no tabs like the OEM piece, hence the tape. A tube of glue was also supplied but not needed. No problems with the finish or weave. Overall I'm happy.
The following users liked this post:
onfireTTS (10-31-2022)
#375