And the track build begins at BBI (987.2 Cayman S PDK)
#16
Rennlist Member
Thread Starter
#17
GT3 player par excellence
Lifetime Rennlist
Member
Lifetime Rennlist
Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
^ must we start the milk and cookie dipping thread again! haha
yes, blender, butcher knife.....
yes, blender, butcher knife.....
#18
Rennlist Member
#19
Rennlist Member
Thread Starter
#20
GT3 player par excellence
Lifetime Rennlist
Member
Lifetime Rennlist
Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
^ looking good.
wing is bigger than mine. compensating for stuff?
i need to check out the uprights. chris says well done load transfer to chassis ala cup car
wing is bigger than mine. compensating for stuff?
i need to check out the uprights. chris says well done load transfer to chassis ala cup car
#21
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
![rockon](https://rennlist.com/forums/graemlins/rockon.gif)
#22
Rennlist Member
Thread Starter
#23
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
![jumper](https://rennlist.com/forums/graemlins/jumper.gif)
![jumper](https://rennlist.com/forums/graemlins/jumper.gif)
#26
Rennlist Member
Thread Starter
#27
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
Those are some big meats up front. Do you have to run any wheel spacers on front or rear?
#28
Rennlist Member
Thread Starter
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I figure since I have big aero in the rear I needed to go a little wider in the front with the 255s. No spacers needed on either the front or back. I might have the roll my front fenders if the front tires are rubbing. I picked up a set of Caragraphic race headers and BBI will install a 997 cup center exhaust.
#29
Rennlist Member
![Default](https://rennlist.com/forums/images/icons/icon1.gif)
I figure since I have big aero in the rear I needed to go a little wider in the front with the 255s. No spacers needed on either the front or back. I might have the roll my front fenders if the front tires are rubbing. I picked up a set of Caragraphic race headers and BBI will install a 997 cup center exhaust.
#30
Rennlist Member
Thread Starter