dunavantent

$100 would be nice on the splitters only. I keep losing mine.

tasracer

splitters r sold

rufm5

These are the ones I have....I didn't paint them since they look sharp on a black car..you can get them at MA Shaw/Getty

Sifly

After a couple of months with the boxes sitting in the garage, I finally got round to fitting the new front pans / splitters and some OEM stone guards behind the front wheels. Fit and finish of the parts is first class. Now just got to watch out for kerbs and potholes!!!

Steven C.

Mine are on. Thanks Gert!

turboholic

I like the fact that you didnt spray those in red, the splitters look good in black.
Any addition in downforce at the front end @ higher speeds??

Steven C.

Only been to about 80mph so don't know on mine?

Vince964T

Must say I didn't see any big change on mine when I put it on but did put the GT wing at the same time. Also it was done during the winter so it was a few month in between...

5 stars for the looks !

Sal 965

Does anybody have a set of these 3.8RS splitters for sale? I've tried looking for them at a number of sources but i'm having no luck at all.

Sal 965

A bump in case anyone has any for sale or know of a source

ADBkennels

I normally order parts from this site coz they have the lowest price and they are a porsche dealer and just local to me. I just ordered them today.
http://www.gaudinporscheparts.com/Po...wse-Parts.shtm

Just use "search by part number" and enter these part numbers
With part numbers provided by Emilios on his earlier post and looking at the picture Sifly posted, the part numbers are 9655051510101C for the left and 9655051520101C for the right. $210 plus shipping for the pair. If these parts are no longer available, they'll contact you. Hopefully these parts are still available.

cobalt

This site appears to list he factory parts standard on the turbo and not the turbo S splitter that he is requesting.

ADBkennels

Cobalt, you are correct. I doubled check the list that I have 'coz I plan to replace mine with a new stock ones. And the number that Emelios posted matched on what I have and these part numbers are for the stock parts. I will call them and cancel my order. Thank you for the clarification.

Now, I am with Sal 95, where can you buy the splitters? And if these are porsche parts, what are the part numbers?

Thanks!

cobalt

Unfortunately that seems to be the problem. When I purchased my set back in 2003 they came with the factory part number you referenced molded in the plastic and had a different part number on a sticker affixed to the parts (Normal Porsche sticker). It would appear they took the factory pans and added the splitters to them and changed the part number. The sticker was visible so I removed it not realizing these numbers are uncommon and not in the Porsche PET. In hindsight it was a number I should have recorded but unfortunately did not. My set also has additional venting heat molded into the plastic which I believe makes my set for the RS/RSR vs the turbo S but I have nothing to confirm that. It would appear that these parts were produced in such limited quantities that they must exist someplace just for the turbo S and RS/RSR or do not have a part number at all. When I picked up the factory turbo S, wing screens and surround for the intercooler. Even though these parts are from the factory none of them have part numbers on them like the stock turbo parts so I guess we are SOL as they say.

Wish I could be of some help but this has been a question we have been bouncing back and forth for years and seem to be out of luck.

Nski

Am after a set too with Sal95