Crazy or there's a mint green coupe in there
#301
Three Wheelin'
Thread Starter
John
#302
Three Wheelin'
Thread Starter
I got my last push pin to click in I kind of cheated I put the push pin in the grommet then got the tabs on the cover lined up with the slots in the push pin and got it to click in👍
#304
Three Wheelin'
Thread Starter
Some of May notice the rear quarter glass is back out of my car I tried reusing the seals and then decided to replace them with factory Porsche seals my old ones looked pretty ratty 😎
#305
Burning Brakes
Still excited about your progress.
#310
Addict
Rennlist Member
Rennlist Member
Nice progress. Looking forward to seeing more of your baby come together.
#311
Three Wheelin'
Thread Starter
^^ Thank You Mr Blue I discovered it hard as hell to buff bumper cover pieces by them selves so I’m in the process of mounting the rear bumper cover. Once that is done I’ll rotate Talia 180 degrees and start on the drivers side.
#312
Addict
Rennlist Member
Rennlist Member
No doubt polishing requires a decent amount of pressure and if you don’t have the pieces perfectly stabilized they will vibrate and move which could damage the paint. I usually tape off all the rubber seals to keep the polish away and prevent damage to them during the polishing with good results.
#313
Three Wheelin'
Thread Starter
No doubt polishing requires a decent amount of pressure and if you don’t have the pieces perfectly stabilized they will vibrate and move which could damage the paint. I usually tape off all the rubber seals to keep the polish away and prevent damage to them during the polishing with good results.
#315
Three Wheelin'
Thread Starter
A
Test fit 😂 the sharp eyes will see no license plate light
Anyway I think I slipped something under instead of over as I have a pretty good gap beneath the center light
Test fit 😂 the sharp eyes will see no license plate light
Anyway I think I slipped something under instead of over as I have a pretty good gap beneath the center light