Heat Shield Speed Nuts - McMaster?
#1
Rennlist Member
Thread Starter
Heat Shield Speed Nuts - McMaster?
Does anyone know offhand which speed/clip-on nuts from McMaster are the correct type/fit for the cat heat shields? Or is there a better source out there?
I need to replace all of mine, but not too enthused about $6/ea for the Porsche part.
http://www.mcmaster.com/#clip-on-nuts/=n0u8md
I need to replace all of mine, but not too enthused about $6/ea for the Porsche part.
http://www.mcmaster.com/#clip-on-nuts/=n0u8md
#2
Rennlist Member
Yes,
Order: 95210A150
More details in my thread here: https://rennlist.com/forums/964-foru...or-method.html
Order: 95210A150
More details in my thread here: https://rennlist.com/forums/964-foru...or-method.html
#4
RicardoD - that was good advice... (and a great write up)
We sell u-nuts by the 10,000's... When I needed some I went to Napa and paid 20x my cost. They fit perfectly and I had the right part picked out in 30 seconds. Much easier than staring at a chart.
In 14 years I have never been asked to quote a stainless u-nut. Auto makers put ever complex platings on them to reduce corrosion rather than yield to the cost of stainless.
We sell u-nuts by the 10,000's... When I needed some I went to Napa and paid 20x my cost. They fit perfectly and I had the right part picked out in 30 seconds. Much easier than staring at a chart.
In 14 years I have never been asked to quote a stainless u-nut. Auto makers put ever complex platings on them to reduce corrosion rather than yield to the cost of stainless.