1990 964 C4 CAB
06-11-2024, 09:23 PM
#256
Rennlist Member
Thread Starter
Con rod time…
These are torqued to 50 ft-lbs or so. I put them in a vice, got my 1/2 drive ratchet and broke them. Then backed the bolts out 1/4” each and tapped the heads with a plastic mallet. This split the halves.
The following users liked this post:
John McM (06-12-2024)
06-20-2024, 10:22 PM
#267
Rennlist Member
Thread Starter
Diff opening
Axle shaft seal pushed in 2mm below the surface
Axle shaft seal slicked up
threaded studs to hold diff flange still with a rod to torque
new shift fork shaft assembly lubed up
silicon grease
end brass bearing
tab
bolted down
The following users liked this post:
John McM (06-21-2024)
The following users liked this post:
John McM (06-22-2024)
