penna964

Rolls nicely

Ready to test run out

Peteinjp

Looking clean man! How did you get the outside of the case looking so good?

What are your plans for the transaxle?

Pete

penna964

Thanks ! I used my CRC heated parts cleaner with multiple cycles and different brushes. I hand detailed for a week or so with maroon scotchbrite and soapy water, then final rinse with CRC brake cleaner. I used a pick in hard to reach areas. A little obsessive I know but I have OCD when it comes to rebuilding engines. I haven’t really thought about the transaxle. What are your thoughts? I will be close to 300hp at the rear wheels in my estimation.

penna964

IMS trueness…

penna964

End setup

penna964

Runout

penna964

Thrust

penna964

Test fit of oil pump, and IMS shaft

penna964

Side studs

Oil pump studs

Case studs

penna964

IMS chain gear

Driven for space to allow snap ring

Round 2

Driven

Space for snap ring

Snap ring

Other side

penna964

Thrust bearing

Number 7

In place and rotating nicely 😊

penna964

First fitting

In spec

Oil pump

Original matching gears

Bearings lubed up

IMS first

Then crank

Final torque

penna964

Oil squirters cleaned

Bearings with calico impregnation

penna964

Removal

Oil nut

Cleaned

penna964

The 3 odd studs