2.8L Turbo, bad iddle runing lean at wot
#47
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
Okay I followed your instructions, swapped the chipboard to the Rogue ECU, moved the switch to the 28pin and NOTHING, NADA the car would not start. swapped the chipboard back to the 28pin dme it started right away. I did notice the resistor with the heat plate gets hot right away is that normal? Iam not going to try the loaner dme anymore and i dont think another chipboard alone is going to fix this issue.
#49
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
Maybe you can load the tune from the loaner ecu into the dme tunner, should I send the tuner too?
#50
Addict
Rennlist Member
Rennlist
Small Business Partner
Rennlist Member
Rennlist
Small Business Partner
#51
Basic Sponsor
Rennlist
Site Sponsor
Rennlist
Site Sponsor
Thread Starter
have you changed email Joshua?