When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
totally agree, if you have the means to make them yourself and it's only going to cost some more time, may as well idealize them as much as you practically can.
but for others that may not read those linked docs above, these seem to be an "80/20" or "95/5" thing where just about anything tapered/radiused is an improvement over a straight cut pipe.
The pics using that particular software might not be as visible but they are the exact ratio for the ideal ellipse. Will post some better pics in the near future. I will probably make them available to anyone just like my intake and exhaust block off plates. Not happening quickly but it will be done.
Originally Posted by V2Rocket
totally agree, if you have the means to make them yourself and it's only going to cost some more time, may as well idealize them as much as you practically can.
but for others that may not read those linked docs above, these seem to be an "80/20" or "95/5" thing where just about anything tapered/radiused is an improvement over a straight cut pipe.