3.0l 16v turbo rod bearing failure
11-20-2012, 04:30 PM
Drifting
Join Date: Dec 2007
Location: England UK
Posts: 2,256
Quote:
Originally Posted by
Duke
These pistons are for 16v.
I know.
11-20-2012, 04:31 PM
Drifting
Join Date: Dec 2007
Location: England UK
Posts: 2,256
That's why I asked about machining them.
11-20-2012, 04:34 PM
Nordschleife Master
Thread Starter
Join Date: Aug 2001
Location: Stockholm, Sweden
Posts: 5,552
Likes: 0
Quote:
Originally Posted by
blade7
I know.
Ok. The compression would be fine (down from 9.5:1 to around 8.2:1) with a 8v head but the valve pockets would need some work.
11-20-2012, 04:34 PM
Three Wheelin'
Join Date: Oct 2004
Location: Northland, New Zealand
Posts: 1,547
Quote:
Originally Posted by
Duke
This is how a whooooole lot of work of looks like...
But the spec sheet for the new engine is starting to take place. Looks like it will be a 3.15l
That'll buff right out...
11-20-2012, 04:36 PM
Nordschleife Master
Thread Starter
Join Date: Aug 2001
Location: Stockholm, Sweden
Posts: 5,552
Likes: 0
Quote:
Originally Posted by
blade7
That's why I asked about machining them.
That would best be done when installed in a block with a temporary mounted 8v head. So that would have to be done by the buyer of these pistons.
11-20-2012, 04:46 PM
Drifting
Join Date: Dec 2007
Location: England UK
Posts: 2,256
Quote:
Originally Posted by
Duke
That would best be done when installed in a block with a temporary mounted 8v head. So that would have to be done by the buyer of these pistons.
OK thanks. Offset grinding a 3.0 crank ?.
11-20-2012, 04:55 PM
Nordschleife Master
Thread Starter
Join Date: Aug 2001
Location: Stockholm, Sweden
Posts: 5,552
Likes: 0
Quote:
Originally Posted by
blade7
OK thanks. Offset grinding a 3.0 crank ?.
Yes I will be doing that for the new engine.
11-20-2012, 05:09 PM
Drifting
Join Date: Dec 2007
Location: England UK
Posts: 2,256
Quote:
Originally Posted by
Duke
Yes I will be doing that for the new engine.
Interesting, sorted out pistons ?.
11-20-2012, 05:23 PM
Nordschleife Master
Thread Starter
Join Date: Aug 2001
Location: Stockholm, Sweden
Posts: 5,552
Likes: 0
Quote:
Originally Posted by
blade7
Interesting, sorted out pistons ?.
I will post a new thread about that engine when it has proceeded a little more
11-22-2012, 07:08 PM
Drifting
Join Date: Dec 2007
Location: England UK
Posts: 2,256
Quote:
Originally Posted by
Duke
I will post a new thread about that engine when it has proceeded a little more
I've got a 2.7 engine and S2 crank, pistons and rods are the next big expense. Think I'll wait a while
2010 ,
30l ,
32 ,
bearing ,
bearings ,
block ,
bmw ,
car ,
crank ,
cross ,
drilled ,
failure ,
powered ,
rod ,
turbo ,
vbulletin